• Energy Research
• Closed Access close
• Restricted close
• Open Source close
• Embargo close
• US close
• RU close
• RS close

A prototype air cycle cooling system, designed for forced cooling of HPOF pipe-type cable, was built under an EPRI contract. Its main components are a turbine and compressor operated on a single high speed shaft and a compact cable. oil to air heat exchanger. Air cooling is supplemented by a spray water system. Tests were conducted on the prototype unit at the EPRI Waltz Mill Cable Test Facility to evaluate its performance and operating characteristics. This paper briefly describes this equipment and presents the results of the test program.

We have investigated the microelectrical properties of CdTe thin films using scanning Kelvin probe force microscopy (SKPFM) and scanning spreading resistance microscopy (SSRM). Two films with the configurations of substrate and superstrate were subjected to the characterization studies. The electrical potential and resistance were properly mapped with the substrate film but not with the superstrate film because the underlying CdS/CdTe junction largely impacted the characterizations. The higher SKPFM potential on grain boundaries (GBs) of the substrate film than on the grain surface indicates positively charged GBs and upward band bending around the GB; therefore, the GBs are either depleted or inverted. The SSRM resistance mapping on this film shows nonuniformities and features that are associated with the grain structure and facets. However, the GBs do not exhibit distinct characteristic resistance. Comparing the low resistance channel along the GBs of high-performance CIGS films, the SSRM mapping of CdTe supports depletion of the GBs. In SSRM measurement, it is critical to adequately indent the probe to the film, and to apply a bias voltage larger than the onset voltage of the probe/film barrier, so that the contact resistance is minimized and that the local spreading resistance of CdTe film beneath the probe is measured.

Chromium (Cr) exposure during gestation causes malformations in animal experiments. In this multicenter case-control study, we initially involved 130 orofacial clefts (OFCs) and 260 controls to assess the association between Cr concentration and risk for OFCs. Then, umbilical cord serum (49 vs. 119) and cord tissue (84 vs. 142) were used to validate the association between Cr and OFCs. We found that maternal serum Cr concentrations in OFC cases were significantly higher than those in controls. Compared with the lowest tertile of maternal serum Cr concentration, the highest tertile of Cr increased the risk for OFCs [OR = 2.14 (1.14-4.05)]. In the validation cohort of umbilical cord serum and tissue, higher concentrations of Cr were associated with increased risks for OFCs in a dose-dependent manner (all Ps for trends <0.05). Cr concentrations in maternal serum and cord serum showed a positive correlation. The Cr concentration in cord serum was inversely correlated with egg and milk consumption frequencies, and the Cr concentration in cord tissue was positively associated with indoor coal burning. In conclusion, prenatal Cr exposure is a risk factor for OFCs, and indoor coal burning during pregnancy may be one of the sources of Cr exposure.

Abstract In this paper, the authors present a method for collecting data on household energy-use behavior. Open-ended interviewing is supplemented by the use of a self-recording system to compensate for a persistent problem in data-gathering on behavior, namely, the gap between what people say they do in interviews and what they actually do. The authors developed and field-tested a self- recording diary which is simple to both use and analyze. Results of that field test are discussed, together with an analysis of who in the household used (or controlled) each of the energy systems in the house. We also compare self-recorded data with interview data to point to differences between reported and recorded behavior. We believe that both the method and the insights into the separation of energy tasks within the household should be of paramount interest to energy planners.

Abstract The effects of ethanol and pentobarbital on flurothyl seizure susceptibility were studied in two lines of mice that were derived by selective breeding with respect to ethanol sleep time. Short-sleep mice (SS) were more susceptible than long-sleep mice (LS) to flurothyl-induced myoclonus, but there was no line difference in susceptibility to clonus. Low doses of ethanol or pentobarbital increased seizure latencies in both populations, and there was no difference between the lines in the effect of these drugs. The lack of difference in response to ethanol in the two populations indicates that the genetic mechanisms which determine sensitivity to ethanol's anticonvulsant action are not identical with those which determine sensitivity to its depressant action.

This research examines the economic implications of different designs for a national low carbon fuel standard (NLCFS) for the road transportation sector. A NLCFS based on the average Carbon Intensity (CI) of all fuels sold generates an incentive for fuel suppliers to reduce the measured CI of their fuels. The economic impacts are determined by the availability of low carbon fuels, estimates of which can vary widely. Also important are the compliance path, reference level CI, and the design of the credit system, particularly the opportunities for trading and banking. To quantitatively examine the implications of a NLCFS, we created the Transportation Regulation and Credit Trading (TRACT) Model. With TRACT, we model a NLCFS credit trading system among profit maximizing fuel suppliers for light- and heavy-duty vehicle fuel use for the United States from 2012 to 2030. We find that credit trading across gasoline and diesel fuel markets can lower the average costs of carbon reductions by an insignificant amount to 98% depending on forecasts of biofuel supplies and carbon intensities. Adding banking of credits on top of trading can further lower the average cost of carbon reductions by 5%–9% and greatly reduce year-to-year fluctuations in credit prices.

The division of return stroke current among the arresters and groundings of two unenergized test distribution lines, one horizontally configured and the other vertically configured, was studied at the International Center for Lightning Research and Testing in Florida. The division of return stroke currents for the vertically configured line was initially similar to the division on the horizontally configured line: at the time the return stroke current reached peak value (after one microsecond, or so) the two closest arresters/grounds on both lines passed about 90% of the total current. However, the time during which the return stroke current flowed primarily through the closest arresters to the neutral conductor was significantly shorter on the vertically configured line. On that line, the arrester current was about equally divided among all four arresters after several tens of microseconds. The arrester current division as a function of time measured on the vertical line was successfully modeled using the published VI-characteristic, while the division on the horizontal line after some tens of microseconds was only successfully modeled if the residual voltage of the two arresters closest to the current injection point was reduced by 20%. Based on the triggered lightning current division observed on our line, the minimum energy absorbed in each of the two arresters closest to the strike point during a typical natural first stroke is estimated to be 40 kJ.

Torrefaction is considered as a method for producing biofuels with improved characteristics compared to those of the “raw” biomass (higher calorific value, moisture resistance, better grindability). The torrefaction process is an endothermic process that is usually carried out in a gaseous atmosphere in the absence of oxygen. To reduce the required heat input, it is proposed to employ the oxidative torrefaction and conduct the process in a fluidized bed agitated with flue gases containing less than 6% oxygen. Preliminary studies of the oxidative torrefaction of sunflower husks, including thermogravimetric analysis of the treated material, have shown that the heat treatment time for the biomass should be at least 5 min. A fluidized bed is a reactor with ideal mixing of the treated material where uniform treatment of raw material particles cannot generally be attained. To overcome this disadvantage of the fluidization technique and achieve the required residence time for biomass in a fluidized bed during a continuous torrefaction process, it was proposed to equip a torrefaction reactor with a series of vertical baffles spaced at 50 mm. These baffles induce a loop-like flow of the processed biomass from the inlet to the outlet of the reactor. To investigate the residence time for husk particles in the reactor, a tracer, which was colored to husk particles' color with a water-soluble dye which did not change the weight and size of the particles, was injected into the bed of uncolored particles. Tracer samples were taken every 30 s at the outlet of the reactor and were analyzed using a special procedure to determine the fraction of colored particles in each sample. This enabled us to gauge the time during which the colored particles injected into the fluidized bed reached the point of their discharge from the bed. Studies performed in a “cold” model of the reactor showed that a series of vertical baffles in the bed can provide the required residence time for biomass in a reactor including commercial reactors. Plates can provide the necessary biomass residence time in the reactor.

Five different hybrid solar power systems using silicon solar cells to produce thermal and electric power are modeled and compared with a hybrid system using a GaAs cell. Among the indices determined are capital cost per unit electric power plus mechanical power, annual cost per unit electric energy, and annual cost per unit electric plus mechanical work. Current costs are taken to be $35,000/sq m for GaAs cells with an efficiency of 15% and $1000/sq m for Si cells with an efficiency of 10%. It is shown that hybrid systems can be competitive with existing methods of practical energy conversion. Limiting values for annual costs of Si and GaAs cells are calculated to be 10.3 cents/kWh and 6.8 cents/kWh, respectively. Results for both systems indicate that for a given flow rate there is an optimal operating condition for minimum cost photovoltaic output. For Si cell costs of $50/sq m optimal performance can be achieved at concentrations of about 10; for GaAs cells costing 1000/sq m, optimal performance can be obtained at concentrations of around 100. High concentration hybrid systems offer a distinct cost advantage over flat systems.