• Energy Research
• Restricted close
• Open Source close
• engineering and technology close
• 8. Economic growth close

Ethylene oxide production process is one of the highest energy consumers in chemical industry, and therefore even a slight improvement in its overall efficiency can have a significant impact on the sustainability of the process. Efficiency improvement can be carried out using the exergy-aided pinch analysis outlined in this paper. The overall exergy loss distribution in different unit operations of an ethylene oxide process was first evaluated and mapped out in the form of “visualized exergetic process flowsheet”. An initial analysis of the four main functional blocks of the process showed that the exothermic reaction block contained the largest exergy loss (6043 and 428 kJ/kg of internal and external losses, respectively) which can be reduced by isothermal mixing, as well as increasing reaction temperature and reduction in pressure drop. The absorption block was also estimated to have the second highest contribution with total exergy losses of 3640 kJ/kg which were mainly due to the cooling column. These losses were then recommended to be reduced by improvements in the concentration and temperature gradients along the tower. Following the block-wise analysis, exergy analysis was then carried out for individual unit operations in each block to pinpoint the main sources of thermal exergetic inefficiency. Thermal solutions to reduce losses were also proposed in accordance with the identified sources of inefficiency, leading to a comprehensive list of cold and hot process streams that could be introduced to reduce losses. Finally, pinch analysis was brought into action to estimate the minimum energy requirements, to select utilities, and to design heat exchanger network. Thus, the methodology used in this work took advantage of both exergy and pinch analyses. The combined thermal-exergy-based pinch approach helped to set energy targets so that all the thermal possible solutions supported by exergy analysis were considered, preventing exclusion of any hot or cold process stream with high potential for heat integration during pinch analysis. Results indicated that the minimum cold utility requirement could be reduced from 601.64 MW (obtained via conventional pinch analysis) to 577.82 MW through screening of streams by the combined methodology.

Biomass is considered one of the most important options in the transition to a sustainable energy system with reduced greenhouse gas (GHG) emissions and increased security of enegry supply. In order to facilitate this transition with targeted policies and implementation strategies, it is of vital importance to understand the economic benefits, uncertainties and risks of this transition. This article presents a quantification of the economic impacts on value added, employment shares and the trade balance as well as required biomass and avoided primary energy and greenhouse gases related to large scale biomass deployment on a country level (the Netherlands) for different future scenarios to 2030. This is done by using the macro-economic computable general equilibrium (CGE) model LEITAP, capable of quantifying direct and indirect effects of a bio-based economy combined with a spread sheet tool to address underlying technological details. Although the combined approach has limitations, the results of the projections show that substitution of fossil energy carriers by biomass, could have positive economic effects, as well as reducing GHG emissions and fossil energy requirement. Key factors to achieve these targets are enhanced technological development and the import of sustainable biomass resources to the Netherlands. (C) 2013 Elsevier Ltd. All rights reserved.

Abstract In April 2012 Argentinean Government nationalized 51% of Repsol shares in YPF. Expropiation of YPF is a new step in a broad list of protectionist and interventionist decisions, such as the nationalization of Aerolineas Argentinas, nationalization of private pension plans, or the amendments of the Central Bank regulations to make the use of reserves more flexible. Institutions set the rules of the game for citizens and companies, allowing incentives and creating expectations. Nationalization of the above mentioned Argentinean companies has created legal uncertainty bringing a relevant increase in the risk premium as a result. Privatization of YPF and its later nationalization, together with the company shareholder composition, and resulting international disputes will be addressed in this article.

In this paper we evaluate the relationships between household expenditures and the environmental impact categories climate change, acidification, eutrophication and smog formation, by combining household expenditures with environmentally extended input–output analysis. Expenditure elasticities are examined with regression analysis, and are compared and interpreted on the basis of insight at the product level. With data from the Netherlands in the year 2000, we find that environmental impact increases with increasing household expenditures, although the degree to which the environmental impact increases differs per impact category. Climate change and eutrophication increase less than proportionally with increasing expenditures. Acidification increases nearly proportionally with increasing expenditures, whereas smog formation increases more than proportionally. It appears that the mix of necessities and luxuries to which an environmental impact is related is essential in explaining the relationship.

This research proposes an innovative solar thermal plant able to generate mechanical power through an optimized system of heliostats with Scheffler-type solar receivers coupled with screw-type steam expanders. Scheffler receivers appear to perform better than parabolic trough collectors due to the high compactness of the focal receiver, which minimizes convective and radiative heat losses even at high vaporization temperatures. At the same time, steam screw expanders are volumetric machines that can be used to produce mechanical power with satisfactory efficiency also by admitting two-phase mixtures and with further advantages compared to steam turbines: low working fluid velocities, low operating pressures, and avoidance of overheating. This study establishes a mathematical model to assess the energetic advantages of the planned solar thermal power system by evaluating the solar-to-electricity efficiency for different off-design working conditions. For this purpose, a numerical model on the Scheffler receiver is initially investigated, thus assessing all the energy losses which affect the heat transfer phase. A thermodynamic model is then developed to evaluate the energy losses and performance of the screw expander under real working conditions. Finally, parametric optimization of the solar energy conversion is performed in a wide range of operating conditions by establishing thermodynamic formulations related to the whole solar electricity generation system. Water condensation pressure and vaporization temperature are so optimized with respect to global energy conversion efficiency which, under the best operating conditions achieved in this research, rises from 10.9% to 14.4% with increasing solar irradiation intensity. Hence, the combined use of screw expanders and Scheffler receivers for solar thermal power system application can be a promising technology with advantages over parabolic dish concentrators. Novelty statement: This research proposes an innovative direct steam solar power plant based on an SRC, with water utilized as both heat transfer and working fluid, equipped with Scheffler solar receivers as a thermal source and screw expanders as work-producing devices. Technical studies and energy assessments of this kind of SEGS at part-load operation do not exist in scientific literature; after reviewing the literature, it was determined that volumetric expanders have been rarely combined with Scheffler receivers for solar thermal power system application. In effect, combined use of screw expanders and Scheffler-type solar concentrator in a direct steam solar power system represents a completely new plant configuration; however, as a promising DSG solar system, at present numerical model of this new sort of SEGS is lacked in literature and the optimum operating conditions have yet to be defined. For this reason, the chief objective of this paper is to define a first parametric optimization of all thermodynamic variables involved to maximize global efficiency of the proposed solar thermal power generation system for ordinary working conditions.

Recent empirical research indicates that certain types of emissions follow an inverted-U or environmental Kuznets curve (EKC) as income grows. This regularity has been interpreted as a possible de-linking of economic growth and patterns of certain pollutants for developed economies. In this paper the empirical basis of this result is investigated by considering some statistical particularities of the various EKC studies performed. It is argued that the inverted-U relationship between income and emissions estimated from panel data need not hold for specific individual countries over time. Based on insights from 'intensity-of-use' analysis in resource economics, an alternative growth model is specified and estimated for three types of emissions (CO

Organic photovoltaics (OPV) have developed into a vast research area. Progress in various directions has made it difficult to monitor the technology's precise development state. We offer a patent landscape analysis over all OPV devices, their substrates and encapsulation materials to provide an overview of patenting activity from a historical, organizational, geographical and technological point of view. Such an exercise is instrumental for private companies and research institutes aiming at both internal or external technology creation. We discuss our findings in the context of the Industrial Life Cycle model and find OPV still residing in the fluid technology development phase. Technology development is still following an exponential growth path, with the majority of patents coming from the Asian continent and in general private companies. For devices, the main technological focus can be traced back to the " H01L-031" international patent classification (IPC) main group. For the queried substrates, the most attention has gone to glass, but paper and textile have drawn significant interest too. Finally, encapsulation is found to be a less mature research field given the smaller number of patent families. The latter shows that the technology has not matured to the level where processing is carried out on a commercial scale

Abstract In this study, we investigate the driving forces behind the changes in residential energy consumption (REC) in China’s urban and rural areas over the 2001–2012 period. Based on the logarithmic mean Divisia index method, the REC changes are decomposed into seven driving forces, which are climate change, energy price, energy expenditure mix, energy cost share (in total expenditure), expenditure share (in income), per capita income and population effects. According to the results, climate effect due to increasing days with abnormal temperature, energy cost share effect characterized by more expenditure to be paid for energy use, income effect describing constant income growth in the residential sector definitely increase REC in both urban and rural areas. In contrast, energy prices and energy expenditure mix effects negatively contribute to the REC increase, respectively because of the increase in energy prices and the transition from the low-priced energy to high-priced energy. Expenditure share and population effects play opposite roles in urban and rural areas, and the reasons and implications are analysed in depth.

We present trends in energy intensities for 56 Dutch economic sectors over the 20-year period 1969–1988. The intensities were calculated by using input–output analysis. The effects of energy-price changes were examined. More than half of the economic sectors show significant declines in energy intensities as a result of increasing energy prices. As a result, the energy intensity for final demand shows a significant decline, although a shift to more energy-intensive sectors was found.

Current economic instruments aimed at climate change mitigation focus mainly on CO(2) emissions, but efficient climate mitigation needs to focus on other greenhouse gases as well as CO(2). This study investigates the distributional effects of climate change taxes on households belonging to different income and lifestyle groups; and it compares the effects of a CO(2) tax with a multiple GHG tax in the UK in terms of cost efficiency and distributional effects. Results show that a multi GHG tax is more efficient than a CO(2) tax due to lower marginal abatement costs, and that both taxes are regressive, with lower income households paying a relatively larger share of their income for the taxes than higher income households. A shift from a CO(2) tax to a GHG tax will reduce and shift the tax burden between consumption categories such as from energy-intensive products to food products. Consumers have different abilities to respond to the tax and change their behavior due to their own socio-economic attributes as well as the physical environment such as the age of the housing stock, location, and the availability of infrastructure. The housing-related carbon emissions are the largest component of the CO(2) tax payments for low income groups and arguments could be made for compensation of income losses and reduction of fuel poverty through further government intervention.