• Energy Research
• Closed Access close
• CA close
• AU close
• IR close
• Energy Research close

Abstract This research attempted to analyze a triple-tube heat exchanger (TTHE) fitted with innovative crimped-spiral ribs to enhance thermal efficiency. The crimped-spiral rib was placed on the top of the internal tube, and the water–alumina nanofluid was employed as the hot fluid within the ribbed side, whereas the two other fluids were pure water. The numerical solutions were performed through the two-phase mixture method, while the turbulent flow was modeled via the Reynolds Stress Model (RSM). The overall heat transfer coefficient (U), heat transfer rate, effectiveness, and performance index enhanced remarkably by using the nanofluid. The greatest increment in the U and effectiveness reached around 44.91 and 41 %, respectively, by the increment of the volume fraction by 0.02. The crimp intensity had an appreciable contribution to the thermal performance. The main mechanism was stronger swirl flow generated by the crimped-spiral rib that yielded boundary layer destruction. The heat transfer capability was increased via the rib pitch decrement and rib height increment. The performance index showed great values even at low volume fractions, which manifested the great merit of the implemented refinements. The thermal attributes were investigated at the first of the result section and then, the hydraulic characteristics were researched.

Abstract In this study, crude cellulose derived from cornstalk, after bleaching, was used as raw material for the synthesis of sodium carboxymethyl cellulose (CMC) by reacting with the cellulose with NaOH and chloroacetic acid at 75 °C for 1.5 h. Effects of alkali dosage, concentration of chloroacetic acid on the physical and chemical properties of the CMC products were investigated. It was revealed that the reactants alkali reagent/chloroacetic acid/cellulose at the molar ratio of 4.6:2.8:1and 4:2.5:1, or at the molar ratio of NaOH/ClCH 2 COOH ≈1.6–1.64, resulted in CMC products of relatively high water solubility. The viscosity-average molecular weight M v of these two CMC products obtained at molar ratios of 4.0:2.5:1 and 4.6:2.8:1 is in the range of 1.94 × 10 4 –2.48 × 10 4 g mol −1 , and the average DS of the two products are 0.57 and 0.85, respectively. As the solute concentration is above 2 wt%, the viscosity of the CMC-water solution exhibits nonlinear (exponential) increasing with increasing the solute concentration (typical of non-Newton fluids).

Abstract Concerns about power quality (PQ) in distribution networks have necessitated the use of PQ measuring/monitoring equipment to detect and analyse PQ problems. As the installation of such equipment at all locations is not economically feasible, minimum number and optimum locations of PQ monitors have been sought in recent researches to meet both economical efficiency and monitoring capability. Focusing on voltage sags, this paper attempts to further reduce the number of PQ monitors obtained by optimum allocation approaches while keeping the desired monitoring capability. Growing number of electric equipment with high sensitivity to voltage sags have raised more concerns about financial losses associated with voltage sags in comparison to other PQ problems. Here, a neural estimator placed at a monitored location is proposed to estimate instantaneous voltage-sag waveforms of a non-monitored sensitive load using local measurements. Echo state network (ESN) is used as the voltage-sag waveform estimator (VSWE). Because of increasing penetration of distributed generations (DGs) and their impacts on voltage-sag performance, they are considered to challenge the estimation task. The proposed ESN-based VSWE is examined on the IEEE 37-bus network. Tests for extensive unseen cases with different fault resistances, fault inception-angles, fault locations and fault types under different load demands and network conditions show acceptable high accuracy of estimations during fault and fault clearing sequences. Furthermore, the performance of the VSWE is investigated during transients due to switching capacitors, DGs, loads and lines.

AbstractCumulus‐intact and ‐denuded unfertilized oocytes from two mouse strains were exposed to 1.5 m ethanol (EtOH) or two cryoproteclant solutions, 1.5 M propanediol (PROH) or 1.5 M dimethylsulfoxide (DMSO), for 4.5 min at 27°C, and the proportion of activating or degenerating oocytes studied. Exposure to DMSO did not significantly increase activation above that of oocytes not exposed to DMSO. Treatment of oocytes in PROH resulted in the activation of up to 87% of viable oocytes. This was significantly higher (P <01) than in control oocytes and comparable to the rate of activation after treatment with EtOH (59–96% activation). In solutions at 1°C, 47% of control oocytes were activated, which was not significantly different from the rate of activation in EtOH (36%) or PROH (50%) at 1°C. Following treatment with PROH, up to 87% of oocytes degenerated within a period of 6 h in vitro. The age of the oocytes (h post hCG) and the time of cumulus removal with the enzyme hyaluronidase, relative to the time of exposure to the chemicals, influenced the level of degeneration in most groups. Significantly fewer oocytes degenerated when cumulus cells were removed before treatment (0–31%) than when the cumulus was left intact throughout the treatment and 6 h culture period (10–87%). Exposure to PROH at 1°C reduced oocyte degeneration to 5%. We conclude that PROH causes significantly greater losses of oocytes as a result of parthenogenetic activation and degeneration than of exposure to DMSO.

Abstract Gas cyclone separators have been widely used in different industries. In this study, to find the best geometrical ratios of Stairmand cyclone separator, computational fluid dynamics (CFD), design of experiments (DOE), multi-gene genetic programming (MGGP), and ten meta-heuristic algorithms were combined. Six geometrical dimensions of the gas cyclone separator including inlet height and width, vortex finder length and its diameter, cylinder height and cone-tip diameter were optimized. The obtained models from MGGP were optimized by ten meta-heuristic algorithms and non-dominated Pareto fronts were analyzed using six unary and binary metrics and PROMETHEE II as a decision making method. According to the optimization results, multi-objective Particle Swarm Optimization (MOPSO) showed the best performance and generated more preferred designs than Stairmand design compared to other algorithms. These preferred designs increased the collection efficiency within 0.36 to 6% and decreased the pressure drop within 3.3 to 27.5% compared to the Stairmand.

Among various bioreactors examined in anaerobic digestion and dark fermentation, UASB bioreactor has shown to be a promising alternative. However, mass transfer resistance and biomass washout have been the issues that reported as draw backs of the granular system in the literature. Another problem associated with such a system is its long start-up period as a result of biomass washout and long microbial granulation stage. In this paper, the results obtained from an UASFF bioreactor in methane (AD process) and hydrogen (DF process) production from POME, are presented to assess mass transfer of substrate into the granules and also study the role of internal packing used in the middle part of reactor in the process stability. The value of effectiveness factor, η, for AD and DF processes were calculated to be 0.96 and 0.94, respectively, indicating that there was no mass transfer resistance due to internal and/or external factors. The results showed that the packing material could retain biomass in the reactor and had outstanding contribution in the granulation enhancement. Its role as a supplementing treatment stage was more significant at low HRTs and up-flow velocities.

A detailed analysis of the effects of ground grid configuration on grounding performance has been carried out for uniform and horizontally stratified soils with multiple layers. The results of the analysis reveal that the most efficient and cost-effective design is highly dependent on soil structure type and characteristics. In the absence of ground rods, grounding grids with uniform mesh size are quite efficient in soils having a thin (relative to grid size) high resistivity (relative to the lower layers) top soil, while grids with small mesh size at the periphery of the grid provide optimum performance in uniform soils and soils with low resistivity top soils. Ground rods were found to be effective only when a significant portion of their length is in contact with a low resistivity soil, as expected.

Experiments were carried out to determine the accuracy and validity of estimations of hepatic blood flow from systemic clearances of ethanol during very low dose (8 μmol∙min−1∙kg−1) infusions of ethanol in anesthetized cats. Systemic clearances were compared with directly measured hepatic blood flow using a hepatic venous long-circuit technique. This technique allowed direct measurement and alteration of hepatic blood flow and collection of arterial, portal, and hepatic venous blood samples without depletion of the animal's blood volume. In 18 cats, Vmax for ethanol was 93 ± 7 μmol∙min−1 per 100 g liver or 21 ± 2 μmol∙min−1∙kg·body weight−1 and Km was 144 ± 19 μM in terms of logarithmic mean sinusoidal concentration. At the dose of 8 μmol∙min−1∙kg body weight−1 used for estimation of hepatic blood flow, extraction was 0.95 ± 0.07 (mean ± SD). Systemic clearance of ethanol overestimated directly measured hepatic blood flow by 15 ± 16%. Hepatic blood flow changes expressed as percentages of the control level were accurately estimated from systemic ethanol clearance (100 ± 10%). Since 73 ± 12% of the infused ethanol was eliminated by the liver and 83 ± 11% was eliminated by the splanchnic bed, an extrasplanchnic uptake of 17% accounted for the overestimation of hepatic blood flow. Estimation of hepatic blood flow from systemic clearances of ethanol during very low dose infusions may have advantages over other clearance methods. Its use in cats was illustrated in a separate series of experiments and it was shown that surgery significantly reduced hepatic blood flow. The method may merit trial for estimation of hepatic blood flow in humans.