• Energy Research
• Closed Access close
• Open Source close
• natural sciences close
• IT close
• NL close

Seagrass systems of the Western Pacific region are biodiverse habitats, providing vital services to ecosystems and humans over a vast geographic range. SeagrassNet is a worldwide monitoring program that collects data on seagrass habitats, including the ten locations across the Western Pacific reported here where change at various scales was rapidly detected. Three sites remote from human influence were stable. Seagrasses declined largely due to increased nutrient loading (4 sites) and increased sedimentation (3 sites), the two most common stressors of seagrass worldwide. Two sites experienced near-total loss from of excess sedimentation, followed by partial recovery once sedimentation was reduced. Species shifts were observed at every site with recovering sites colonized by pioneer species. Regulation of watersheds is essential if marine protected areas are to preserve seagrass meadows. Seagrasses in the Western Pacific experience stress due to human impacts despite the vastness of the ocean area and low development pressures.

Abstract Economically harvesting energy from a microbial fuel cell (MFC), increasing its electrical power production, and developing its role as a practical energy supply, needs a low-cost and high-performance design of the MFC compartments. According to this strategy, a novel monolithic membrane electrode assembly (MEA) was fabricated and evaluated as an air–cathode in a single-chamber MFC (SCMFC). The MEA was made of bacterial cellulose (BC), conductive multi-walled carbon nanotubes (CNT), and nano-zycosil (NZ). BC, as a nano-celluloses with oxygen barrier property, can maintain anaerobic conditions for the anode compartment. Binder-less CNT coating on BC avoids costly binders such as poly-tetra fluoro ethylene (PTFE) and Nafion and decreases the MEA charge transfer resistance. NZ, as a very cheap modifier, not only prevents the anolyte leakage but also provides more MEA’s active sites for the oxygen reduction reaction (ORR). The electrochemical performance of the MEA was compared to a PTFE- based gas diffusion electrode (GDE) in the SCMFC. The MEA cell provided a pulse power density of 1790 mW/m2, roughly twice as high as the pulse power density of GDE (920 mW/m2). SCMFC’s internal resistance decreased from 1.84 KΩ (with GDE) to 0.8 KΩ (with MEA). Also, the cell’s columbic efficiency increased from 4.2% (with GDE) to11.7% (with MEA). Additionally, the capacitance of the MEA (65 mF) was much higher than the value for GDE (0.73 mF). Thus, the MEA compared to the GDE showed higher performance in the SCMFC for electricity generation and wastewater treatment at a lower cost.

Urea is the most common nitrogen (N) fertilizer in agriculture, due to its cheaper price and high N content. Although the reciprocal influence between NO3- and NH4+ nutrition are well known, urea (U) interactions with these N-inorganic forms are poorly studied. Here, the responses of two tomato genotypes to ammonium nitrate (AN), U alone or in combination were investigated. Significant differences in root and shoot biomass between genotypes were observed. Under AN+U supply, Linosa showed higher biomass compared to UC82, exhibiting also higher values for many root architectural traits. Linosa showed higher Nitrogen Uptake (NUpE) and Utilization Efficiency (NUtE) compared to UC82, under AN+U nutrition. Interestingly, Linosa exhibited also a significantly higher DUR3 transcript abundance. These results underline the beneficial effect of AN+U nutrition, highlighting new molecular and physiological strategies for selecting crops that can be used for more sustainable agriculture. The data suggest that translocation and utilization (NUtE) might be a more important component of NUE than uptake (NUpE) in tomato. Genetic variation could be a source for useful NUE traits in tomato; further experiments are needed to dissect the NUtE components that confer a higher ability to utilize N in Linosa.

We studied the performance of the AZTI Marine Biotic Index AMBI manipulating input data collected from lagoonal ecosystems. Our data set consisted of macrofaunal abundance and biomass counts gathered at a variety of sites at which the disturbance status was known. Input data were also manipulated using a set of transformations of increasing severity. Biotic indices were calculated using raw and transformed abundance, biomass and production. Among the three categories of AMBI-based indices, medium transformation of data gave the highest correlation with pressures. However, increasing the severity of transformation generally resulted in a decrease of the correlation with environmental factors. The relative importance of ecological groups changed when using abundance or biomass, sometimes leading to an improved ecological status classification. Being biomass and production more ecologically relevant than abundance, using them to derive AMBI-based new indices seems intriguing, at least in lagoonal waters, where the community is naturally disturbed and dominated by opportunists.

Abstract An alkaline earth boro-aluminosilicate glass (Eagle XG), a soda-lime glass, and a light-weight polyethylene-terephthalate (PET) foil, used as typical substrates for photovoltaics, were treated by an energetic proton beam (3 MeV, dose 106–107 Gy) corresponding to approx. 30 years of operation at low Earth orbit. Properties of the irradiated substrates were characterized by atomic force microscopy, optical absorption, optical diffuse reflectance, Raman spectroscopy, X-ray photoelectron spectroscopy, Fourier-transform infrared (FTIR) spectroscopy, and terahertz (THz) spectroscopy. Minimal changes of optical and morphological properties are detected on the bare Eagle XG glass, whereas the bare PET foil exhibits pronounced increase in optical absorption, generation of photoluminescence, as well as mechanical bending. On the other hand, the identical substrates coated with Indium-tin-oxide (ITO), which is a typical material for transparent electrodes in photovoltaics, exhibit significantly higher resistance to the modifications by protons while ITO structural and electronic properties remain unchanged. The experimental results are discussed considering a potential application of these materials for missions in space.

The Pannonian basin is an integral part of the convergence zone between the Eurasian and Nubian plates characterized by active subductions of oceanic and continental plates, and formation of backarc basins. The first part of this paper presents an overview of the evolution of the Alpine-Mediterranean region in order to understand the large scale crustal and upper mantle processes in and around the Pannonian basin, resulting a collage of terranes of Alpine and Adriatic origin. It will be followed by a summary of the history of sedimentation, volcanism and tectonic activity. As an illustration, three regional cross sections have been prepared on the base of seismic and borehole data. Reviewing current tectonic ideas and models, we come up with a speculative tectonic scenario depicting Alcapa and Tisza-Dacia as orogenic wedges detached from their mantle lithosphere in the Alpine and Adriatic/Dinaric collision zone during the Late Oligocene to Early Miocene. They suffered a dramatic thermal impact leading to crustal melting during extrusion, when these crustal flakes could have been directly superimposed on the asthenosphere in the Carpathian embayment. Since then, the large part of the Pannonian has been cooling and a new mantle lithosphere growing. Geothermal data show that the Pannonian basin with cessation of volcanic activity in the Late Miocene is still very hot and Miocene to Quaternary clastic basin fill, together with karstified Mesozoic carbonates form good geothermal reservoirs of regional extent. In addition to these gravity-driven aquifer systems, a strongly overpressured reservoir can be found below a regional pressure seal in synrift strata and fractured basement rocks. Eventually, we show maps of geothermal installations in the Pannonian basin and suggest that at the present level of knowledge and geophysical surveying it is easy to find additional resources, however proper water management is a critical issue to avoid harmful drawdown of the groundwater table.

In the present study, Tween 80, a non-ionic surfactant, has been used for enhanced hydrogen production by crude glycerol bioconversion using co-culture of Enterobacter aerogenes and Clostridium butyricum. The purpose of introducing the surfactant was to decrease the crude glycerol viscosity, so that apparent solubility and bioavailability of glycerol could be improved at the expenses of pretreatment steps. Experiments were planned using central composite design (CCD); crude glycerol and Tween 80 concentrations were optimized whereas, hydrogen production, glycerol utilization and viscosity of the media were considered as responses. The response surface for quadratic model showed, Tween 80 concentration had significant effect (p < 0.05) on all the three responses. Using the optimized conditions at 17.5 g/L crude glycerol and 15 mg/L Tween 80, hydrogen production reached a maximum of 32.1 ± 0.03 mmol/L of medium. The increase in hydrogen production was around 1.25-fold in presence of Tween 80 in comparison to its absence with 25.56 ± 0.91 mmol/L production. Selected optimum conditions were also validated against absence of crude glycerol (4.69 ± 0.76), with pretreated crude glycerol (20.06 ± 0.51) and across mono-culture system (15.43 ± 0.79 to 22.14 ± 0.94). Introduction of Tween 80 to the fermentation medium improved the glycerol utilization rate, resulting in increased hydrogen production and eliminated pretreatment steps.

Abstract The general acceptance of the CO2 geological storage by stakeholders passes through the assessment and mitigation of risks, potentially induced or increased by the disposal activity. Injection of moderate to large quantities of CO2 in the sub-surface may unbalance local stress and trigger earthquakes if faults are critically stressed, condition that is not easily verifiable. Pilot sites are therefore the best way to proceed further in order to address such challenging issues. In such cases, the reconnaissance of faults and seismicity in the sub-surface, before the onset of activity, is mandatory. In this paper, we present studies carried out in the site where the Sotacarbo Fault Lab is going to be installed. This facility will be located in a very low seismic hazard region of central Mediterranean, where reports on historical large earthquakes are poor. We show results from a series of experiments aimed to monitor the background seismicity around the pilot site. As expected, seismicity is almost absent down to small magnitude close to the future injection-test well. Further seismic imaging of the sub-surface layers obtained by ambient noise tomography offers the ability to resolve the presence of a seismicity-free fault located in the first 200 m below the surface, of which the last episode of activity is difficult to assess. Our results encourage the use of this site to follow the response of the system to injection of small quantity of CO2.