• Energy Research
• 2021-2025close
• mechanical engineering close
• Energies close

Nitrogen reduction reaction (NRR) and nitrate reduction reaction (NO3−RR) provide a potential sustainable route by which to produce ammonia, a next-generation energy carrier. Many studies have been conducted over the years, mainly emphasizing material design and strategies to improve catalytic performance. Despite significant achievements in material design and corresponding fundamental knowledge, the produced ammonia is still very limited, which makes it prone to bias. The presence of interferants (e.g., cations and sacrificial reagents), the pH of the solution, and improper analytical procedure can lead to the over or underestimation of ammonia quantification. Therefore, the selection of the appropriate ammonia quantification method, which meets the sample solution condition, along with the proper analytical procedures, is of great importance. In this review, the state-of-the-art ammonia quantification method is summarized, emphasizing the advantages, limitations, and practicality for NRR and NO3−RR studies. Fundamental knowledge of the quantification method is introduced. Perspective on the considerations for selecting the suitable quantification method and for performing the quantification process is also provided. Although non exhaustive, this focused review can be useful as a guide to design the experimental setup and procedure for more reliable ammonia quantification results.

The proposed special issue (SI) has invited submissions related to renewable energy, energy storage, power converters and electric drive systems for electrified transportation and smart grid applications [...]

The article describes the principles based on which it is possible to obtain energy from renewable sources more efficiently. The principles use the conventional DC-DC interleaved buck converter based on the common electronic component types and the control strategy. A novelty of such a proposed solution lies in the methods which are not new, but with the right combination, better results can be achieved. The resulting method can be implemented into various topologies where the highest efficiency for wide input power is required. In case of the renewable energy sources where the power can vary hugely during the day, the proposed method can be implemented. Therefore, the article provides several steps, from calculation through simulation to experimental results that brings reader close to understanding of a such proposed solution.

Deployment of photovoltaic (PV) systems has recently been encouraged for large-scale and small-scale businesses in order to meet the global green energy targets. However, one of the most significant hurdles that limits the spread of PV applications is the dust accumulated on the PV panels’ surfaces, especially in desert regions. Numerous studies sought the use of cameras, sensors, power datasets, and other detection elements to detect the dust on PV panels; however, these methods pose more maintenance, accuracy, and economic challenges. Therefore, this paper proposes an intelligent system to detect the dust level on the PV panels to optimally operate the attached dust cleaning units (DCUs). Unlike previous strategies, this study utilizes the expanded knowledge and collected data for solar irradiation and PV-generated power, along with the forecasted ambient temperature. An expert artificial intelligence (AI) computational system, adopted with the MATLAB platform, is utilized for a high level of data prediction and processing. The AI was used in this study in order to estimate the unprovided information, emulate the provided measurements, and accommodate more input/output data. The feasibility of the proposed system is investigated using actual field data during all possible weather conditions.

With the construction of the UHV (Ultra High Voltage) AC/DC hybrid power grid and the large-scale access to renewable energy such as wind power, frequency dynamic fluctuation has become a prominent problem affecting the safe and stable operation of large power grids. The expansion of the scale of the power system makes it impossible to use traditional fine modeling to analyze the power system. In order to reduce the calculation scale and storage capacity of power system frequency dynamic simulation, it is necessary to make appropriate equivalent simplification of the external system, so the appropriate dynamic equivalent method is of great significance. This paper mainly studies the equivalent model suitable for frequency dynamic analysis of large power grids. Firstly, the typical models of generator set and load are simplified, and the parameters that have a great influence on frequency in the simplified model are obtained through characteristic analysis. Then, a dynamic aggregation method of generator governor and prime mover parameters and load parameters based on regulation performance weighting (the parameters of the generator or load are weighted and summed according to its regulation ability on the system) is proposed. This method is applied to the simulation example of the East China Power Grid. The simulation proves that the frequency of the East China Power Grid before and after equivalence can be consistent under four different faults, which verifies the effectiveness of the equivalent method proposed in this paper in the frequency dynamic analysis of large power grids.

Electricity imbalance pricing provides the ultimate incentive for generators and suppliers to contract with one another ahead of time and deliver against their obligations. As delivery time approaches, traders must judge whether to trade-out a position or settle it in the balancing market at the as-yet-unknown imbalance price. Forecasting the imbalance price (and related volumes) is therefore a necessity in short-term markets. However, this topic has received surprisingly little attention in the academic literature despite clear need by practitioners. Furthermore, the emergence of algorithmic trading demands automated forecasting and decision-making, with those best able to extract predictive information from available data gaining a competitive advantage. Here we present the case for developing imbalance price forecasting methods and provide motivating examples from the Great Britain’s balancing market, demonstrating forecast skill and value.

The use of natural gas as an energy source is increasing significantly due to its low greenhouse gas emissions. However, the common methods of natural gas storage and transportation, such as liquefied or compressed natural gas, are limited in their applications because they require extreme conditions. Gas hydrate technology can be a promising alternative to conventional approaches, as artificially synthesized hydrates provide an economical, environmentally friendly, and safe medium to store energy. Nevertheless, the low rate of hydrate formation is a critical problem that hinders the industrial application of this technology. Therefore, chemical promoters are being developed to accelerate the kinetics of gas hydrate formation. In this paper, the effect of new sodium sulfosuccinate compounds, synthesized based on glycerol and pentaerythritol, on methane hydrate formation was studied. Experiments under dynamic conditions using high-pressure autoclaves demonstrated that the conversion of water-to-hydrate forms increased from 62 ± 5% in pure water to 86 ± 4% for the best promoter at concentration 500 ppm. In addition, the rate of hydrate formation increases 2–4 times for different concentrations. Moreover, none of the synthesized reagents formed foam, compared to sodium dodecyl sulfate, in which the foam rate was 3.7 ± 0.2. The obtained reagents showed good promotional properties and did not form foam, which makes them promising promoters for gas hydrate technology.