• Energy Research
• 2021-2025close
• Closed Access close
• Open Source close
• 6. Clean water close

Abstract In this paper, coupled governing equations were proposed to simulate three-dimensional heat conduction and moisture transport in the nuclear waste repository. Because there will be a large temperature gradient near inner and outer boundaries of the bentonite buffer layer, and the heat driven moisture transport is introduced in the governing equation of moisture transport. By applying the Fourier and Laplace transforms, the governing equations were converted to the Bessel equations, and the Laplace-domain solutions to temperature and moisture distributions were derived through the inverse Fourier transform. The reliability of the proposed solutions was verified through comparative analysis with the line heat source model. These analytical solutions were applied to obtain the evolutions of temperature field and moisture distribution near the waste canister. Finally, a sensitivity study was performed to analyze the effects of relevant parameters on the heat driven moisture transport.

Forest soil acidification caused by acid deposition is a serious threat to the forest ecosystem. To investigate the liming effects of biomass ash (BA) and alkaline slag (AS) on the acidic topsoil and subsoil, a three-year field experiment under artificial Masson pine was conducted at Langxi, Anhui province in Southern China. The surface application of BA and AS significantly increased the soil pH, and thus decreased exchangeable acidity and active Al in the topsoil. Soil exchangeable Ca2+ and Mg2+ in topsoil were significantly increased by the surface application of BA and AS, while an increase in soil exchangeable K+ was only observed in BA treatments. The soil acidity and active Al in subsoil were decreased by the surface application of AS. Compared with the control, soluble monomeric and exchangeable Al in the subsoil was decreased by 38.0% and 29.4% after 3 years of AS surface application. There was a minimal effect on soluble monomeric and exchangeable Al after the application of BA. The soil exchangeable Ca2+ and Mg2+ in the subsoil increased respectively by 54% and 141% after surface application of 10 t ha-1 AS. The decrease of soil active Al and increase of base cations in subsoil were mainly attributed to the high migration capacity of base cations in AS. In conclusion, the effect of surface application of AS was superior to BA in ameliorating soil acidity and alleviating soil Al toxicity in the subsoil of this Ultisol.

Abstract CBM reservoirs are extremely vulnerable to damage due to their complex pore structure. So, changing pore structures in CBM reservoirs is of vital importance for reducing reservoirs damage. Organic solvents have been considered as additives into fracturing fluids to enhance production because they can enhance the pore connectivity and loosening macromolecular network structure. It is thus of great interests to investigate how organic solvents (ethanol and ethylene glycol ether) change micropore structures and fluid distribution. In this study, samples were selected from different wells completed in No. 3 coal seam, Zhaozhuang minefield. Low-pressure nitrogen adsorption (LP-N2GA) experiments were conducted on coal samples to evaluate the changes in pore-structure parameters including specific surface area (SSA), pore diameter, and pore volume. NMR experiments were conducted on coal samples to evaluate the changes in fluid distribution. Analyzing the LP-N2GA results suggests ethylene glycol ether and ethanol can effectively increase SSA, pore diameter, and opening degree of pores in coal samples. Comparative analysis of NMR results indicates that ethylene glycol ether consistently reduces the irreducible water saturation (Swir) in samples. The average value of Swir of raw samples is 0.8670 and the average value of Swir of samples treated with ethylene glycol ether value is 0.7644. Considering the pore-structure alterations, this study demonstrates that ethylene glycol ether is more preferable for enhancing recovery from CBM reservoirs compared with ethanol.

Bioplastics are alternatives of conventional petroleum-based plastics. Bioplastics are polymers processed from renewable sources and are biodegradable. This study aims at conducting an environmental impact assessment of the bioprocessing of agricultural wastes into bioplastics compared to petro-plastics using an LCA approach. Bioplastics were produced from potato peels in laboratory. In a biochemical reaction under heating, starch was extracted from peels and glycerin, vinegar and water were added with a range of different ratios, which resulted in producing different samples of bio-based plastics. Nevertheless, the environmental impact of the bioplastics production process was evaluated and compared to petro-plastics. A life cycle analysis of bioplastics produced in laboratory and petro-plastics was conducted. The results are presented in the form of global warming potential, and other environmental impacts including acidification potential, eutrophication potential, freshwater ecotoxicity potential, human toxicity potential, and ozone layer depletion of producing bioplastics are compared to petro-plastics. The results show that the greenhouse gases (GHG) emissions, through the different experiments to produce bioplastics, range between 0.354 and 0.623 kg CO2 eq. per kg bioplastic compared to 2.37 kg CO2 eq. per kg polypropylene as a petro-plastic. The results also showed that there are no significant potential effects for the bioplastics produced from potato peels on different environmental impacts in comparison with poly-β-hydroxybutyric acid and polypropylene. Thus, the bioplastics produced from agricultural wastes can be manufactured in industrial scale to reduce the dependence on petroleum-based plastics. This in turn will mitigate GHG emissions and reduce the negative environmental impacts on climate change.

Abstract Economically harvesting energy from a microbial fuel cell (MFC), increasing its electrical power production, and developing its role as a practical energy supply, needs a low-cost and high-performance design of the MFC compartments. According to this strategy, a novel monolithic membrane electrode assembly (MEA) was fabricated and evaluated as an air–cathode in a single-chamber MFC (SCMFC). The MEA was made of bacterial cellulose (BC), conductive multi-walled carbon nanotubes (CNT), and nano-zycosil (NZ). BC, as a nano-celluloses with oxygen barrier property, can maintain anaerobic conditions for the anode compartment. Binder-less CNT coating on BC avoids costly binders such as poly-tetra fluoro ethylene (PTFE) and Nafion and decreases the MEA charge transfer resistance. NZ, as a very cheap modifier, not only prevents the anolyte leakage but also provides more MEA’s active sites for the oxygen reduction reaction (ORR). The electrochemical performance of the MEA was compared to a PTFE- based gas diffusion electrode (GDE) in the SCMFC. The MEA cell provided a pulse power density of 1790 mW/m2, roughly twice as high as the pulse power density of GDE (920 mW/m2). SCMFC’s internal resistance decreased from 1.84 KΩ (with GDE) to 0.8 KΩ (with MEA). Also, the cell’s columbic efficiency increased from 4.2% (with GDE) to11.7% (with MEA). Additionally, the capacitance of the MEA (65 mF) was much higher than the value for GDE (0.73 mF). Thus, the MEA compared to the GDE showed higher performance in the SCMFC for electricity generation and wastewater treatment at a lower cost.

AbstractSlaughterhouses generate highly polluted effluents, and if not treated before discharge can cause major adverse environmental and public health impacts. Treatment of this waste by anaerobic digestion can reduce those impacts while producing a potentially valuable source of energy. The purpose of this study was to investigate this process efficiency under pilot operating conditions for a more accurate scaling up. Blood waste from a slaughterhouse was treated in a pilot‐scale digester of 30 dm3 total volume under mesophilic temperature conditions. Operating parameters such as pH, alkalinity, organic loading, volatile fatty acids, biogas composition, total and volatile solids were monitored in order to study the behavior of the fermentation process. The results show that no significant inhibition were caused by the accumulation of volatile fatty acids, due to the high buffering capacity of treated sludge. An efficient reduction of organic matter was obtained with a COD decrease of about 67% within 40 days of fermentation. The biogas produced was of a good quality with high CH4 yields (above 70%) and low CO2 yields, corresponding to a biomethane potential of 225.9 dm3 CH4/kg TVS. Logistic model described accurately the methane production kinetic and enables an easy process scaling up for industrial applications.

Abstract Globally, three-quarter of a billion people live without electricity. Besides, hundreds of million use a solar lantern for less than 4 h a day. Most of the access-deprived are in the Global South, predominantly in Sub-Saharan Africa and South Asia. The United Nations framed the seventh Sustainable Development Goal to improve access. Solar photovoltaic powered mini-grids are increasingly extending better service to deprived regions. However, poor load-factor and expensive storage adversely affect viability. Also, these mini-grids do not support infrequent large loads to avoid further loss of load-factor. Electric cooking is efficient and non-polluting; water treatment facilities can save millions from contaminant and pathogen by providing clean water. Besides, both electric cooking and water treatment are less expensive than alternatives. But mini-grids frequently do not support these. Indeed, the presence of sustained productive loads favourably influences the mini-grid economy. This study investigates the role of critical household loads to deliver similar bearing on the mini-grid economy. Results underscore realisation of desirable impact with household collaboration under a demand-response program. Collaborative consumption can lower initial investment by 62% and reduce the unit energy cost to $0.23. Also, cooperation improves the mini-grid load factor and promotes viability. Additionally, fast deployment needs during and after Covid-19 remains inherently supported while mitigating the pandemic induced financial stress of both consumer and mini-grid operator. This study of 88 nation-states underscores that demand response in a mini-grid can not only improve affordability for all consumers, but it can also bring 186 million people within affordable access.

Abstract Natural resources exist independent of human intervention. Although these interventions can and do affect the balance between ecological and biological diversity conditions these resources support, and their use to promote economic development. Currently, the unsustainable use of these resources threatens this balance, calling for more sustainable patterns of natural resource use and conservation. The primary responsibility for ensuring the proper balance lies with governments, leading to various policies and programs to preserve natural resources. The ultimate goal is to make the masses aware of natural assets’ importance and encourage their sustainable use. To successfully implement, however, these government practices require public communication and participation, and the full consideration of public opinion at various levels of governance. A predictive analytics framework is proposed for understanding public opinion on government policies to improve sustainable water governance. An integrated policy initiative to balance water resources use and conservation launched by the Indian government served as a test case for applying the framework in an attempt to accurately classify the opinion polarity related to the policy. The conventional feature extraction is applied to pre-processed datasets to extract the relevant features. Subsequently, swarm-based feature selection is applied to filter out optimal features. Lastly, opinion mining and textual analysis are performed to determine the most relevant water management factors that need immediate attention. The proposed framework serves as a policy evaluation strategy in the water management domain. The paper closes with a discussion of the general applicability of the proposed framework.

Much of New South Wales and southern Queensland suffered from extreme drought from 2017 to 2019. This study models drought and bushfires impacts using VU‐TERM, a multi‐regional, dynamic CGE model. Prolonged drought pushed national real GDP to 0.7 per cent or more below base in 2018–2019 and 2019–2020. NSW’s real GDP fell relative to forecast by 1.1 per cent or $6.9 billion in 2018–2019 and 1.6 per cent or $10.2 billion in 2019–2020. These impacts reflect a severe diminution of farm output, given that agriculture accounts for around 1.6 per cent of NSW’s income. Bushfires exacerbated 2019–2020 losses. We assume that there is a full recovery in seasonal conditions in 2020. However, prolonged drought and bushfire destruction deplete farm capital through depressed investment and diminished herd numbers. Consequently, the income earning capacity of farms in recovery remains below that of a no drought base. The net present value of the national welfare loss is $63 billion, split between $53 billion in losses from drought and $10 billion from bushfires. The latter excludes any valuation of human lives lost, flora, fauna or forestry destruction. In the longer term, adaptation and policy responses will need to reflect the expectation of increased frequency of adverse climatic events.