• Energy Research
• Closed Access close
• Restricted close
• Open Source close
• 7. Clean energy close
• 13. Climate action close
• 3. Good health close

A prototype air cycle cooling system, designed for forced cooling of HPOF pipe-type cable, was built under an EPRI contract. Its main components are a turbine and compressor operated on a single high speed shaft and a compact cable. oil to air heat exchanger. Air cooling is supplemented by a spray water system. Tests were conducted on the prototype unit at the EPRI Waltz Mill Cable Test Facility to evaluate its performance and operating characteristics. This paper briefly describes this equipment and presents the results of the test program.

Abstract Compared with other traditional energy sources, renewable energy, which results the less pollution and has numerous resources, is a significant factor in addressing the current issues of the serious environmental pollution and the resource depletion. Large-scale renewable energy integrated to the grid could bring change in both morphological structure and operation modes of energy transmission. Therefore, it is necessary to research the evolution mechanism of the future transmission network with a high proportion of the renewable energy. In this paper, an evolution framework of power system with high proportion of renewable energy is proposed. Firstly, a network equivalence and simplification based on power transfer distribution factors (PTDFs) is proposed, which can effectively simplify the decision-making process of evolution of large-scale power system. Then, an annual production simulation (8760 h) which takes into account renewable energy and load fluctuations is used to find out the bottleneck of the power grid. Based on the above methods, evolution strategy of power system with high proportion of renewable energy is studied for finding out optimal expansion strategy. A real power system of Zhejiang province is used as a test system. Test results demonstrate the feasibility of the proposed evolution framework.

The association between alcohol and blood glucose levels, and whether it is modified by other variables, was examined in a cross-sectional survey of 5518 staff aged 40-65 years at worksites in Auckland and Tokoroa, New Zealand. Diabetes was determined by oral glucose-tolerance tests using 1999 WHO criteria. Usual alcohol intake in the previous 3 months, measured by food frequency questionnaire, was related positively with fasting triglycerides and high-density-lipoprotein (HDL)-cholesterol, and unrelated with fasting glucose, but had an approximate U-shaped relationship with 2-h glucose, which varied from an adjusted mean (S.E.) of 5.62 (0.08) mmol/l in non-drinkers, down to 5.34 (0.08) mmol/l in light alcohol drinkers (alcohol or =20 g per day). Adjusting further for triglycerides increased the mean difference in 2-h glucose for all drinking categories compared with non-drinkers, particularly for heavy drinkers (> or =20 g per day), from -0.22 (S.E. = 0.10) to -0.37 (0.10) mmol/l. The confounding effect of triglycerides suggests alcohol may affect the diabetes risk by a mechanism related to the triglyceride metabolism, which in heavy drinkers may counteract the protective effect of improved insulin sensitivity, resulting in the U-shaped relationship between alcohol and diabetes described in previous studies.

Abstract Canada has numerous climatic and geographical regions and the Canadian housing stock (CHS) is diversified in terms of vintage, geometry, construction materials, envelope, occupancy, energy sources and heating, ventilation and air conditioning system and equipment. Therefore, strategies to achieve net zero energy (NZE) status with the current stock of houses need to be devised considering the unique characteristics of the housing stock, the economic conditions and energy mix available in each region. Identifying and assessing pathways for converting existing houses to NZE buildings at the housing stock level is a complex and multifaceted problem and requires extensive analysis on the impact of energy efficiency and renewable/alternative energy technology retrofits on the energy use and GHG emissions of households. A techno-economic analysis of retrofitting renewable/alternative energy technologies in the CHS to reduce energy consumption and GHG emissions was conducted to develop strategies to achieve or approach NZE status for Canadian houses. The results indicate that substantial energy savings and GHG emission reductions are techno-economically feasible for the CHS through careful selection of retrofit options. While achieving large scale conversion of existing houses to NZEB is not feasible, approaching NZE status is a realistic goal for a large percentage of Canadian houses.

Cold-start (subzero startup) capability of polymer electrolyte fuel cell (PEFC) is of great importance. In this paper, the effects of the micro-porous-layer (MPL), varying start-up temperatures, start-up current density variation on the cold-start operation are investigated. We found PEFC with anode micro-porous-layer (AMPL), compared with one with CMPL, has higher possibility of successful cold start. By analyzing the anode and cathode pressure revolution of PEFC, the effect of MPL on the super cooled water removal and ice formation at different temperatures (-7,-10,-15 and-20℃) are discussed . In addition, we investigate the ice distribution in MEA through the X-ray device, by comparing the initial image when fuel cells shut down (before the produce the water) and final image after failed cold-start. We also explore the negative voltage phenomenon in the initial process of cold-start operation.

Abstract The increasing energy demand in developing countries has jeopardised energy security, necessitating the employment of solar energy to augment conventional energy sources. It is important to assess the annual performance parameters of solar power plants to understand its place in energy generation. This study analyses the performance and economic viability of a large-scale solar power park located in India. A 50 MWp Solar Photovoltaic Power Park (SPPP) located at Sakunala, in the State of Andhra Pradesh, is one of the largest solar power park in India, and the site receives an average solar radiation of 5.5–6.0 kWh/m2/day. The design, performance analysis, economic feasibility, and greenhouse gas mitigation of the 50 MWp SPPP is presented. The energy yields, performance ratio (PR), capacity utilization factor (CUF), and losses are assessed based on the IEC 61724 standards for two consecutive years (2018–2019 and 2019–2020). The performance results obtained are compared with the PVsyst simulation results. The PR, CUF, and energy yields are estimated as 0.779, 0.24, and 107,326.4 MWh in 2018–2019 and 0.691, 0.22, and 96,707.336 MWh in the year 2019–2020, respectively. The PVsyst simulator evaluates the PR, CUF, and energy yields as 0.80, 0.24, and 106,022 MWh, respectively. Further, the effect of power curtailment policies on solar PV projects is also discussed and the effect of curtailment policy on the economy of the solar power park in terms of payback period and emissions are analysed. The performance of the SPPP is also compared with those of other PV plants installed all over the world.

Microbial fuel cell (MFC) is a sustainable and energy efficient technology, which uses graphite as cathode for hydrogen peroxide (H2O2) production often with simultaneous power production. Nevertheless, slow kinetics of oxygen reduction reaction (ORR) at the surface of graphite often results in poor performance of MFC. In an attempt to improve the performance of MFC for in‐situ H2O2 production, a treatment of graphite cathode using nitric acid was performed. The treatment was conducted in three steps (i) heat treatment at 450°C for 2 h; (ii) acid treatment with concentrated nitric acid for 5 h; and (iii) drying at 120°C for 2 h. After the treatment, four times increase in surface area of treated cathode (GR‐HA) was observed. Energy‐dispersive X‐ray spectroscopy (EDX) and Fourier transform infrared (FTIR) analysis revealed the presence of nitrogen and quinone based functional groups on the surface of GR‐HA. Cyclic voltammetric (CV) analysis of GR‐HA cathode further confirmed the production of H2O2 at the peak current value of −3.7 mA and on‐set potential of −0.1 V. Following CV analysis, H2O2 production experiments were performed in a dual chamber MFC using GR‐HA as cathode. Maximum 150 mg/L of H2O2 was produced with simultaneous power production of 36.438 mW/m2. Approximately, 25% increase in both H2O2 and power production was observed in the case of G cathode. Subsequently, Fenton oxidation experiments were performed (with GR‐HA and GR‐CA cathodes) to determine the efficacy of in‐situ produced H2O2. This resulted in an increase of 8.28%, 11.04%, and 31.32% in decolorization, chemical oxygen demand (COD), and Total Organic Carbon (TOC) removal efficiency, respectively. © 2016 American Institute of Chemical Engineers Environ Prog, 36: 382–393, 2017

Abstract For fast reactor design and analysis, our laboratory uses, amongst others, the ERANOS code system. Unfortunately, the publicly available version of ERANOS does not have the most recent nuclear data. Therefore, it was decided to implement an integrated processing system to generate cross sections libraries for the ECCO cell code, as well as covariance data. Cross sections are generated from the original ENDF files. For our purposes, it is important to ascertain that the ECCO cross section libraries are of adequate quality to allow design and analysis of advanced fast reactors in an academic context. In this paper, we present an analysis of the MZA/MZB benchmarks with nuclear data from JENDL-4.0, JEFF-3.1.2 and ENDF/B-VII.1. Results are that reactivity is generally well predicted, with an uncertainty of about 1% due to covariances of the nuclear data. Reaction rate ratios are satisfactorily calculated, as well as the flux spectrum and reaction rate traverses. Some problems remain: the magnitude of the void effect is not satisfactorily calculated, and reaction rate traverses are not always satisfactorily calculated. On the whole, the ECCO libraries are sufficient for design and analysis tasks in an academic context. For high-precision calculations, such as required for licensing tasks and detailed design calculations, data adjustment is still necessary as the “native” covariance data in the ENDF files is not accurate enough.

Abstract This paper describes an integrated framework to evaluate short-run marginal costs (SRMC) in hydrothermal systems, taking into account the chronological aspects of reservoir operation, transmission constraints, equipment failures, hydrological variation and load uncertainty. The resulting SRMC values are used to calculate circuit revenues, which are then compared with investment requirements. It is shown that the representation of these probabilistic factors substantially increases revenues, in contrast with the widely reported under-recovery found in studies which only represent normal operating conditions. Case studies with the Brazilian North-Northeastern system are presented and discussed.