• Energy Research
• Closed Access close
• US close
• GB close
• Transport Research close

This paper presents an integrated vehicle model to simulate simultaneously the driver, powertrains, chassis, body, road condition, vehicle dynamics and the Active Suspension (AS) system with/without an energy harvesting module. The developed model is used to investigate the ride comfort and influences of energy harvesting AS system on the total energy consumption of battery Electric Vehicles (EVs) relative to EVs with a passive suspension system. Preliminary simulation results show that compared to EVs with a passive suspension system, the ones with AS system improve ride comfort, up to 31% reduction of the vehicle body acceleration RMS value, with an expense of higher energy consumption. This expense can be reduced to about 2.8% when using an energy harvesting AS system. Simulation results also demonstrate that the available energy for recuperation during the AS system operation is significant in relation to the regenerative braking energy of the propulsion system, up to approx. 70% on bumpy road surfaces.

The private motor vehicles are significantly important means of transportation in modern lifestyle, however, these also contribute to a large proportion of the total air pollution and primary energy consumption. In order to develop green transportation system, it becomes imperative to use integrated technologies to achieve reduced emissions and utilize renewable energy. Electric vehicles (EVs) have been considered as one of these technologies to transform the traditional vehicle mix. However, the uptake of EV has been debated on factors like cost, performance (autonomous mileage), charging point infrastructure construction, energy saving, policy and end users’ adaptation. Present study investigates the technology feasibility (which usually refer to EVs’ cost, EV charging, supplier’s customer services quality, EV travel performance) and users’ adaptation of EV in Beijing, which is a key driver for the EV uptake into the Beijing transportation system. The relevant data have been collected and analyzed in the form of questionnaire survey around all of these factors. While considering the user perception and satisfaction, safety of charging and energy bills have also been investigated. According to the data analysis, it has been found the policy of ‘No traffic restrictions for EVs’ (the traffic restrictions means for certain date, from Monday to Friday the motor vehicles with the last register number of 1 and 6, 2 and 7, 3 and 8, 4 and 9, 5 and 0, are restricted to travel, respectively), the availability of the charging infrastructure and technical support are the most significant factors affecting the users’ opinions on using EVs.

Plug-in electric vehicles can potentially emit substantially lower CO2 emissions than internal combustion engine vehicles, and so have the potential to reduce transport emissions without curtailing personal car use. Assessing the potential uptake of these new categories of vehicles requires an understanding of likely consumer responses. Previous in-depth explorations of appraisals and evaluations of electric vehicles have tended to focus on ‘early adopters’, who may not represent mainstream consumers. This paper reports a qualitative analysis of responses to electric cars, based on semi-structured interviews conducted with 40 UK non-commercial drivers (20 males, 20 females; age 24–70 years) at the end of a seven-day period of using a battery electric car (20 participants) or a plug-in hybrid car (20 participants). Six core categories of response were identified: (1) cost minimisation; (2) vehicle confidence; (3) vehicle adaptation demands; (4) environmental beliefs; (5) impression management; and, underpinning all other categories, (6) the perception of electric cars generally as ‘work in progress’ products. Results highlight potential barriers to the uptake of current-generation (2010) plug-in electric cars by mainstream consumers. These include the prioritization of personal mobility needs over environmental benefits, concerns over the social desirability of electric vehicle use, and the expectation that rapid technological and infrastructural developments will make current models obsolete. Implications for the potential uptake of future electric vehicles are discussed.

Abstract Alternative vehicle technologies have a great potential to minimize the transportation-related environmental impacts, reduce the reliance of the U.S. on imported petroleum, and increase energy security. However, they introduce new uncertainties related to their environmental, economic, and social impacts and certain challenges for widespread adoption. In this study, a novel method, uncertainty-embedded dynamic life cycle sustainability assessment framework, is developed to address both methodological challenges and uncertainties in transportation sustainability research. The proposed approach provides a more comprehensive, system-based sustainability assessment framework by capturing the dynamic relations among the parameters within the U.S. transportation system as a whole with respect to its environmental, social, and economic impacts. Using multivariate uncertainty analysis, likelihood of the impact reduction potentials of different vehicle types, as well as the behavioral limits of the sustainability potentials of each vehicle type are analyzed. Seven sustainability impact categories are dynamically quantified for four different vehicle types (internal combustion, hybrid, plug-in hybrid, and battery electric vehicles) from 2015 to 2050. Although impacts of electric vehicles have the largest uncertainty, they are expected (90% confidence) to be the best alternative in long-term for reducing human health impacts and air pollution from transportation. While results based on deterministic (average) values indicate that electric vehicles have greater potential of reducing greenhouse gas emissions, plug-in hybrid vehicles have the largest potential according to the results with 90% confidence interval.

Air taxis are currently being demonstrated. Few studies have quantified their external effects in reducing on-road vehicle fuel consumption. The hypothesis of this paper is that air taxis may divert some drivers away from congested traffic corridors, improve traffic speed and fuel economy, and reduce congestion-induced energy consumption. A model is developed that links several key components: mode choice, the relationship between travel demand and traffic speeds, the relationship between traffic speeds and fuel economies, and the heterogenous value of travel time. It is applied to the route from downtown Los Angeles to Los Angeles International Airport, where at peak hours 38,200 vehicles attempt to use the route that has an hourly capacity of 17,200 vehicles. The model estimates that, with conservative assumptions and near-term technologies, diverting 3.2% of the traffic to air taxis could produce a 15% reduction in traffic vehicle fuel use. With optimistic assumptions and mature technologies, the study estimates that diverting 20% of traffic could reduce the traffic vehicle fuel use by about 74%. The key insight is that if a small share of congested travelers switched to air taxis, motivated by private benefits of time savings, significant external benefits for other road travelers (time savings and fuel savings) and to society (reduced energy use and emissions), would ensue creating a win-win-win outcome. These estimates (which are not intended as predictions because of the stated limitations) strongly suggest the need to consider the external energy effect in future cost-benefit analyses of air taxi technologies.

As part of continuous efforts to identify effective and durable anodes for use in cathodic protection (CP) of reinforced concrete bridge members, a water-based, electrically conductive paint was evaluated for use as the secondary anode in CP systems for inland concrete piers. The paint was used in two CP systems—one designed and built approximately 6 years ago and the other 8 years ago—to protect the concrete piers of two pairs of twin bridges in Virginia. When adjusted properly, the two systems provided more than sufficient protection to the reinforcing steel. Natural paint deterioration occurred in both systems. In the 8-year-old system, this deterioration ranged from 0 to 0.37 percent. In the 6-year-old system, it ranged from 0 to 0.14 percent. Most of the deterioration occurred at the ends of the pier caps, where the concrete is not sheltered from rain by a deck overhang. The overall performance of the conductive paint in these CP systems was better than expected. Its effectiveness could last for at least 15 years, even longer if minor paint deterioration is touched up as early as possible. This type of conductive paint should, therefore, be considered a suitable secondary anode for use in CP of inland concrete piers.

Abstract This paper presents a study of the combined influence of battery models and sizing strategy for hybrid and battery-based electric vehicles. In particular, the aim is to find the number of battery (and supercapacitor) cells to propel a light vehicle to run two different standard driving cycles. Three equivalent circuit models are considered to simulate the battery electrical performance: linear static, non-linear static and non-linear with first-order dynamics. When dimensioning a battery-based vehicle, less complex models may lead to a solution with more battery cells and higher costs. Despite the same tendency, when a hybrid vehicle is taken into account, the influence of the battery models is dependent on the sizing strategy. In this work, two sizing strategies are evaluated: dynamic programming and filter-based. For the latter, the complexity of the battery model has a clear influence on the result of the sizing problem. On the other hand, a modest influence is observed when a dynamic programming strategy is followed.

Current and forecasted use of air transportation by businesses in Minnesota using the Standard Industrial Classification is described. The research is based upon a study on air service and commercial and industrial activity in Minnesota required by the Minnesota legislature in 1996. Purchases from the air transportation sector that includes scheduled and nonscheduled passenger and freight services are based upon the 1993 IMPLAN input-output model for Minnesota and Bureau of Economic Analysis (BEA) and Bureau of Labor Statistics (BLS) forecasts for Minnesota. In addition to intraindustry transfers within the air transportation sector, purchases of air transportation are dominated by business associations, management and consulting services, and the U.S. Postal Service sectors. These four sectors also represent the sectors with the largest share of purchases of air transportation. BLS historical and forecast data suggest that the major group of industries that purchased air transportation in 1977 will remain intact through 2005. Under BEA forecasts for Minnesota, air transportation purchases by all industry sectors will increase more rapidly than other transportation modes. BEA also forecasts the air transportation component of gross state product growing faster than forecasted passenger originations at Minneapolis–St. Paul (MSP). The implications of the BEA forecasts will be considered in the next update of activity forecasts for MSP. This research is considered only the first step in understanding the role of air transportation to commerce and industry in Minnesota and other states.

In Bangladesh, prawn (Macrobrachium rosenbergii) farming remains dependent on the capture of wild postlarvae as hatchery production is still inadequate. However, prawn postlarvae fishing has been accompanied by concerns over recent climate change. Different climatic variables including cyclone, salinity, sea level rise, water temperature, flood, rainfall, and drought have had adverse effects on coastal ecosystem, thus determining a decline in the availability of prawn postlarvae and thereby catch. The households of postlarvae fishers also face a variety of socioeconomic constraints due to climate change. Considering extreme vulnerability to the effects of climate change, an integrated approach needs to be introduced to cope with the challenges.