• Energy Research
• Restricted close
• CN close
• CA close
• IN close

Abstract This Special Section provides introduction to the 15th Conference Process Integration, Modelling and Optimisation for Energy Saving and Pollution Reduction (PRES 2012). In this editorial introduction, the editors are highlighting the individual articles included in this issue and discussing the main points. The main areas of this issue can be summarised as: Process Integration for Energy Saving, Integrating Renewable Energy Sources and Energy Optimisation issues.

A 3D model is developed to describe an anode-supported planar solid oxide fuel cell (SOFC), by Ansys/Fluent evaluating reactions including methane steam reforming (MSR)/water-gas shift (WGSR) reactions in thick anode layer and H2-O2/CO-O2 electrochemical reactions in anode active layer, coupled with heat, mass species, momentum, and ion/electron charges transport processes in SOFC. The predicted results indicate that electron/ion exchange appears in the very thin region in active layers (0.018 mm in anode and 0.01 mm in cathode), based on three phase boundary, operating temperature and concentration of reactants (mainly H2). Active polarization happening in active layers dominates over concentration and ohmic losses. High gradient of current density exists near interface between electrode and solid conductor due to the block by gas channel. It is also found the reaction rates of MSR and WGSR along main flow direction and cell thickness direction decrease due to low concentration of fuel (CH4) caused by mass consumption. With increasing operating temperature from 978 K to 1088 K, the current density and the reaction rate of MSR are increased by 10.8% and 5.4%, respectively. While ion current density is 52.9% higher than in standard case, and H2 is consumed by 5.1% more when ion conductivity is doubled. CO-O2 has been considered in charge transfer reaction in anode active layer and it is found that the current density and species distributions are not sensitive, but WGSR reaction will be forced backwards to supply more CO for CO-O2 electrochemical reaction.

Abstract Field experiences have shown that sub-synchronous oscillation (SSO) can occur in direct-drive wind farms with VSC-HVDC systems. Due to the complexity of the detailed wind farm model, a dynamic equivalent model, with a reasonable order reduction of the detailed model and still reflecting inside-wind-farm and wind-farm-grid SSO characteristics is essential. In this paper, based on the principle that similar matrices have identical eigenvalues, the SSO analysis of an N-machine wind farm with VSC-HVDC system is conducted by simplifying it into two single-machine systems. The modeling method of the two single-machine systems is presented. Four case studies are presented to verify the effectiveness of the proposed model when compared with the detailed model in various scenarios. The proposed model is also benchmarked with the output multiplication-based equivalent model (OMM). Comparison results show that although the system order is reduced significantly, the proposed simplified equivalent model can still reflect inside-wind-farm and wind-farm-grid SSO modes in various scenarios. Meanwhile, the rationality of the OMM in terms of the wind-farm-grid SSO analysis is verified theoretically.

China has achieved impressive rapid economic growth over the past 30 years but accompanied by significant extreme weather events and environmental changes caused by global change and overfast urbanization. Using the absolute hazards index (AHI), we assessed the spatial distribution patterns and related health effects of 4 major extreme natural disasters, including drought, floods (landslides, mudslides), hails, and typhoons from 2000 to 2011 at the provincial level in China. The results showed that (1) central and south China were the most affected by the 4 natural disasters, and north China suffered less; (2) the provinces with higher AHI suffered most from total death, missing people, collapse, and emergently relocated population; (3) the present health emergency response system to disasters in China mainly lacks a multidisciplinary approach. In the concluding section of this article, suggestions on preparedness and rapid response to extreme health events from environmental changes are proposed.

Abstract The aim of the present study was to assess the influence of substrate concentration on the fermentative hydrogen production from sweet sorghum extract, in a continuous stirred tank bioreactor. The reactor was operated at a Hydraulic Retention Time (HRT) of 12 h and carbohydrate concentrations ranging from 9.89 to 20.99 g/L, in glucose equivalents. The maximum hydrogen production rate and yield were obtained at the concentration of 17.50 g carbohydrates/L and were 2.93 ± 0.09 L H 2 /L reactor/d and 0.74 ± 0.02 mol H 2 /mol glucose consumed, corresponding to 8.81 ± 0.02 L H 2 /kg sweet sorghum, respectively. The main metabolic product at all steady states was butyric acid, while ethanol production was high at high substrate concentrations. The experiments showed that hydrogen productivity depends significantly on the initial carbohydrate concentration, which also influences the distribution of the metabolic products.

The main objective of this paper is to study the possible use of D-mannitol as phase change material (PCM) for thermal energy storage. PCM are materials that have high phase change enthalpy and this thermophysical property gives them the ability to store energy as latent heat. D-mannitol is a material which has different morphological phases (polymorphism); here were studied b-form and d-form. Different polymorphic forms produce changes on melting point of D-mannitol. For this reason it is necessary to establish a suitable working temperature range for the use of D-mannitol as phase change material. The thermal characterization was performed with DSC analysis using 0.5 K min-1 slow-dynamic method. Polymorphism analysis of D-mannitol was analyzed to associate the thermal behavior obtained by DSC with a specific polymorphic phase. D-mannitol presented three different thermal behaviors: the first one had a melting peak at 167 oC, the second was a double melting peak at 155 oC and 166 oC, and the third a single peak at 155 oC. Due to irregular results, two working range were studied and through the thermal characterization, it was possible to define a working range where Dmannitol could be used as PCM for energy storage: this range is between 135 and 175 oC. Furthermore, it was possible to differentiate two crystalline phases of D-mannitol applying FT-IR analysis and to link them with thermal behavior observed in DSC. The percentage of times each thermal behavior is observed in DSC analysis was calculated. d-form is obtained 15.8% of analyzed cycles, the b-form appears 44.7% of times, and an intermediate transition between the two phases is found 39.5% of cycles.

Decreasing nutrient losses from excessive synthetic fertilizer inputs is the direct and valid way to address low nutrient use efficiency and the related environmental consequences. Here, we established a comprehensive database of nitrogen (N), phosphorus (P), and carbon (C) losses from rice paddy fields in China, which we used to evaluate fertilization-induced losses and the impact of environmental factors, and to mitigate losses by adopting alternative fertilization options and setting input thresholds. Our results showed that most N-loss pathways had exponential increases with additional N input. In average, 23.8% of the N applied was lost via NH3 (16.1%), N2O (0.3%), leaching (4.8%), and runoff (2.6%). Total P loss was approximately 2.7% of the input, composed of leaching (1.3%) and runoff (1.4%). C lost as CH4 accounted for 4.9% of the organic C input. A relative importance analysis indicated that climate or soil variation rather than fertilizer rate was the dominant factor driving N and P leaching, and CH4 emissions. Based on the sensitivity of multiple N-loss pathways to N fertilization, we propose upper thresholds for N inputs of 142–191 kg N ha−1 across four rice types, which would avoid dramatic increases in N losses. Compared to conventional chemical fertilization, alternative fertilization options had diverse performances: enhanced-efficiency N fertilizer reduced N loss rate by 7.8 percent points and the global warming potential (GWP, considering N2O and CH4 emissions) by 28.8%; combined manure and chemical N fertilizer reduced N loss rate by 9.0 percent points but increased the GWP by 56.9%; straw return had no effect on total N loss but almost doubled the GWP. Using nutrient sources most appropriate to site-specific conditions is demonstrated as a robust way to decrease nutrient losses. Setting nutrient input thresholds would also contribute to the mitigation of environmental pollution, especially in regions with poor fertilization recommendation systems.

Abstract Electrolyte-separator-free fuel cell (EFFC) is a new emerging energy conversion technology. The EFFC consists of a single-component of nanocomposite material which works as a one-layer fuel cell device contrary to the traditional three-layer anode–electrolyte–cathode structure, in which an electrolyte layer plays a critical role. The nanocomposite of a single homogenous layer consists of a mixture of semiconducting and ionic materials that provides the necessary electrochemical reaction sites and charge transport paths for a fuel cell. These can be accomplished through tailoring ionic and electronic (n, p) conductivities and catalyst activities, which enable redox reactions to occur on nano-particles and finally accomplish a fuel cell function.