• Energy Research
• Closed Access close
• Open Source close
• natural sciences close
• IT close
• FR close

Seagrass systems of the Western Pacific region are biodiverse habitats, providing vital services to ecosystems and humans over a vast geographic range. SeagrassNet is a worldwide monitoring program that collects data on seagrass habitats, including the ten locations across the Western Pacific reported here where change at various scales was rapidly detected. Three sites remote from human influence were stable. Seagrasses declined largely due to increased nutrient loading (4 sites) and increased sedimentation (3 sites), the two most common stressors of seagrass worldwide. Two sites experienced near-total loss from of excess sedimentation, followed by partial recovery once sedimentation was reduced. Species shifts were observed at every site with recovering sites colonized by pioneer species. Regulation of watersheds is essential if marine protected areas are to preserve seagrass meadows. Seagrasses in the Western Pacific experience stress due to human impacts despite the vastness of the ocean area and low development pressures.

Abstract Economically harvesting energy from a microbial fuel cell (MFC), increasing its electrical power production, and developing its role as a practical energy supply, needs a low-cost and high-performance design of the MFC compartments. According to this strategy, a novel monolithic membrane electrode assembly (MEA) was fabricated and evaluated as an air–cathode in a single-chamber MFC (SCMFC). The MEA was made of bacterial cellulose (BC), conductive multi-walled carbon nanotubes (CNT), and nano-zycosil (NZ). BC, as a nano-celluloses with oxygen barrier property, can maintain anaerobic conditions for the anode compartment. Binder-less CNT coating on BC avoids costly binders such as poly-tetra fluoro ethylene (PTFE) and Nafion and decreases the MEA charge transfer resistance. NZ, as a very cheap modifier, not only prevents the anolyte leakage but also provides more MEA’s active sites for the oxygen reduction reaction (ORR). The electrochemical performance of the MEA was compared to a PTFE- based gas diffusion electrode (GDE) in the SCMFC. The MEA cell provided a pulse power density of 1790 mW/m2, roughly twice as high as the pulse power density of GDE (920 mW/m2). SCMFC’s internal resistance decreased from 1.84 KΩ (with GDE) to 0.8 KΩ (with MEA). Also, the cell’s columbic efficiency increased from 4.2% (with GDE) to11.7% (with MEA). Additionally, the capacitance of the MEA (65 mF) was much higher than the value for GDE (0.73 mF). Thus, the MEA compared to the GDE showed higher performance in the SCMFC for electricity generation and wastewater treatment at a lower cost.

Urea is the most common nitrogen (N) fertilizer in agriculture, due to its cheaper price and high N content. Although the reciprocal influence between NO3- and NH4+ nutrition are well known, urea (U) interactions with these N-inorganic forms are poorly studied. Here, the responses of two tomato genotypes to ammonium nitrate (AN), U alone or in combination were investigated. Significant differences in root and shoot biomass between genotypes were observed. Under AN+U supply, Linosa showed higher biomass compared to UC82, exhibiting also higher values for many root architectural traits. Linosa showed higher Nitrogen Uptake (NUpE) and Utilization Efficiency (NUtE) compared to UC82, under AN+U nutrition. Interestingly, Linosa exhibited also a significantly higher DUR3 transcript abundance. These results underline the beneficial effect of AN+U nutrition, highlighting new molecular and physiological strategies for selecting crops that can be used for more sustainable agriculture. The data suggest that translocation and utilization (NUtE) might be a more important component of NUE than uptake (NUpE) in tomato. Genetic variation could be a source for useful NUE traits in tomato; further experiments are needed to dissect the NUtE components that confer a higher ability to utilize N in Linosa.

We studied the performance of the AZTI Marine Biotic Index AMBI manipulating input data collected from lagoonal ecosystems. Our data set consisted of macrofaunal abundance and biomass counts gathered at a variety of sites at which the disturbance status was known. Input data were also manipulated using a set of transformations of increasing severity. Biotic indices were calculated using raw and transformed abundance, biomass and production. Among the three categories of AMBI-based indices, medium transformation of data gave the highest correlation with pressures. However, increasing the severity of transformation generally resulted in a decrease of the correlation with environmental factors. The relative importance of ecological groups changed when using abundance or biomass, sometimes leading to an improved ecological status classification. Being biomass and production more ecologically relevant than abundance, using them to derive AMBI-based new indices seems intriguing, at least in lagoonal waters, where the community is naturally disturbed and dominated by opportunists.

AbstractMononuclear trivalent lanthanide complexes with formula [Ln(L)(NO3)3] [in which L=4,4‐difluoro‐8‐(2′:2′′;6′′:2′′′‐terpyridin‐4′′‐yl)‐1,3,5,7‐tetramethyl‐2,6‐diethyl‐4‐bora‐3a,4a‐diaza‐s‐indacene (Boditerpy)] are reported for Ln=Yb, Nd, Er, La and Gd. According to the crystal structure of the Yb complex, the lanthanide ion is bound to the terdentate terpyridine and the inner coordination sphere of the nine‐coordinate lanthanide ion is completed by three bidentate nitrate anions. The coordination polyhedron can be described as a distorted tricapped antiprism. The terpyridine chelate is almost planar and tilted by nearly 60° from the indacene subunit. FT‐IR spectra confirm the bidentate binding mode of the nitrate anions for the other complexes. NMR and ES‐MS spectra (through characteristic isotopic patterns) confirm the chemical formulation. The complexes have high molar absorption coefficients in the visible spectral region (65 000 M−1 cm−1 at 529 nm) and display sizeable NIR luminescence (900 to 1600 nm, for Ln=Yb, Nd and Er), upon irradiation through the electronic state of the indacene moiety at 514 nm. Crystal‐field splitting was analysed at low temperature. The quantum yield of the Yb solution (10−4 M) in dichloromethane amounts to 0.31 %, corresponding to a sensitisation efficacy of the ligand of ca. 63 %.

AbstractCellulose and lignin nanoparticles are high‐value‐added products obtained from lignocellulosic biomasses through several steps of cellulose purification and lignin extraction. These steps drastically reduce the potential feedstock revenue when carried out as stand‐alone methodologies. To increase biomass yields, we describe here a strategy to design a biorefinery focused on producing cellulose and lignin nanoparticles as main products, but also aim to recover and benefit from other biomass components using only water‐based processes. Sequential pressurized liquid extractions and diluted acid and alkaline treatments were carried out to fractionate elephant grass biomass, yielding (for every 100 g of biomass): 30 g of cellulose pulp (converted to 9 g of cellulose nanocrystals and 9 g of cellulose nanofibers); 10 g of lignin (used to produce 8.5 g of stable colloidal lignin nanoparticles by probe‐sonication in water); 7.5 g of extractives (e.g. sterols and phenolics) and 23 g of xylose (converted to 4.1 g of furfural). Alternatively, to allow for the flexible use of the cellulose fraction in the proposed biorefinery, 22 g of glucose could be produced by enzymatic hydrolysis. The results demonstrate that water‐based processes are suitable for a holistic use of biomass, providing a comprehensive set of high‐value‐added co‐products that are renewable and cost‐effective chemical, cosmetic, food, polymer and pharmaceutical solutions.

Use of a pilot-scale fixed-film bioreactor was investigated for remediation of bromate contamination within groundwater. Bromate reduction with stoichiometric production of bromide was observed, providing supporting evidence for complete reduction of bromate with no production of stable intermediates. Reduction of 87-90% bromate from an influent concentration of 1.1 mg L(-1) was observed with retention times of 40-80 h. Lower retention times led to decreases in bromate reduction capability, with 11.5% removal at a 10 h retention time. Nitrate reduction of 76-99% from a 30.7 mg L(-1) as NO(3)(-) influent was observed at retention times of 10-80 h, although an increase in nitrite production to 2.7 mg L(-1) occurred with a 10 h retention time. Backwashing was not required, with the large plastic packing media able to accommodate biomass accumulation without decreases in operational efficiency. This study has provided proof of concept and demonstrated the potential of biological bromate reduction by fixed-film processes for remediation of a bromate contaminated groundwater source.

The phosphate (P) fertilizer industry generates a highly hazardous and acidic wastewater. The present study reports the evaluation of an integrated precipitation and Enhanced Biological Phosphorus Removal (EBPR) process for the treatment of fertilizer plant wastewater and effluent detoxification, assessed by microtoxicity and seed germination tests. Effluent samples were collected from a local P fertilizer industry and were characterized by their high fluoride and P content. First, the samples were pre‐treated by precipitation of P and fluoride ions using hydrated lime. The resulting low‐fluoride and phosphorus effluent was then treated with the EBPR process to monitor the simultaneous removal of carbon, nitrogen, and phosphorus. Phosphorus removal included a two‐stage anaerobic/aerobic system operating under continuous flow. Pre‐treated wastewater was added to the activated sludge and operated for 160 days in the reactor. The operating strategy included increasing the organic loading rate from 0.3 to 1.2 g chemical oxygen demand (COD)/L day. The stable and high removal rates of COD, NH4+‐N, and PO43−‐P were then recorded. The mean concentrations of the influent were approximately 3600 mg COD/L, 60 mg N/L and 14 mg P/L, which corresponded to removal efficiencies of approximately 98%, 86%, and 92%, respectively. The microtoxicity of the treated wastewater was then monitored by LUMIStox and its phytotoxicity was investigated on cress, tomato, wheat, maize, ryegrass, and alfalfa seed germination. LUMIStox tests showed that treatment allowed a significant toxicity removal. Moreover, the untreated wastewater inhibited the species germination even when diluted 10 times, whereas a positive effect of treated wastewater was noticed. © 2013 American Institute of Chemical Engineers Environ Prog, 33: 463–471, 2014

Abstract The general acceptance of the CO2 geological storage by stakeholders passes through the assessment and mitigation of risks, potentially induced or increased by the disposal activity. Injection of moderate to large quantities of CO2 in the sub-surface may unbalance local stress and trigger earthquakes if faults are critically stressed, condition that is not easily verifiable. Pilot sites are therefore the best way to proceed further in order to address such challenging issues. In such cases, the reconnaissance of faults and seismicity in the sub-surface, before the onset of activity, is mandatory. In this paper, we present studies carried out in the site where the Sotacarbo Fault Lab is going to be installed. This facility will be located in a very low seismic hazard region of central Mediterranean, where reports on historical large earthquakes are poor. We show results from a series of experiments aimed to monitor the background seismicity around the pilot site. As expected, seismicity is almost absent down to small magnitude close to the future injection-test well. Further seismic imaging of the sub-surface layers obtained by ambient noise tomography offers the ability to resolve the presence of a seismicity-free fault located in the first 200 m below the surface, of which the last episode of activity is difficult to assess. Our results encourage the use of this site to follow the response of the system to injection of small quantity of CO2.