• Energy Research
• Restricted close
• natural sciences close
• CN close
• IN close

A water-soluble organic redox couple (TT−/DTT) and new organic dyes (D45 and D51) have been developed for aqueous dye-sensitized solar cells (DSCs). An optimal efficiency of 3.5% was obtained using the D51 dye and an optimized electrolyte composition. The highest IPCE value obtained was 68% at 460 nm.

The oleaginous alga Chlorella protothecoides accumulates lipid in its biomass when grown in nitrogen-restricted conditions. To assess the relationship between nitrogen provision and lipid accumulation and to determine the contribution of photosynthesis in mixotrophic growth, C. protothecoides was grown in mixo- and heterotrophic nitrogen-limited continuous flow cultures. Lipid content increased with decreasing C/N, while biomass yield on glucose was not affected. Continuous production of high lipid levels (57% of biomass) was possible at high C/N (87-94). However, the lipid production rate (2.48 g L(-1) d(-1)) was higher at D=0.84 d(-1) with C/N 37 than at D=0.44 d(-1) and C/N 87 even though the lipid content of the biomass was lower (38%). Photosynthesis contributed to biomass and lipid production in mixotrophic conditions, resulting in 13-38% reduction in CO2 production compared with heterotrophic cultures, demonstrating that photo- and heterotrophic growth occurred simultaneously in the same population.

The Indian Ocean Experiment (INDOEX) was an international, multiplatform field campaign to measure long-range transport of air pollution from South and Southeast Asia toward the Indian Ocean during the dry monsoon season in January to March 1999. Surprisingly high pollution levels were observed over the entire northern Indian Ocean toward the Intertropical Convergence Zone at about 6°S. We show that agricultural burning and especially biofuel use enhance carbon monoxide concentrations. Fossil fuel combustion and biomass burning cause a high aerosol loading. The growing pollution in this region gives rise to extensive air quality degradation with local, regional, and global implications, including a reduction of the oxidizing power of the atmosphere.

Electricity generation integrated with xylose degradation was investigated in a two-chamber mediator-less microbial fuel cell (MFC). Voltage output followed saturation kinetics as a function of xylose concentration for concentration below 9.7 mM, with a predicted maximum of 86 mV (6.3 mW m(-2) or 116 mW m(-3)) and half-saturation constant (K(s)) of 0.29 mM. Xylose concentrations from 0.5 mM to 1.5 mM resulted in coulombic efficiencies and maximum voltage ranging from 41+/-1.6% to 36+/-1.2% and 55+/-2.0 mV to 70+/-3.0 mV respectively. Xylose degradation rate increased with increasing xylose concentration up to 9.7 mM and the predicted maximum degradation rate was 0.13 mM h(-1) and K(s) of 3.0 mM. Stirring by nitrogen in the anode chamber led to 99+/-2.3 mV maximum voltage (8.4+/-0.4 mW m(-2) or 153+/-7.1 mW m(-3)) and 5.9+/-0.3% coulombic efficiency at MFC running time 180 h, which were respectively 17+/-1.2% and 37+/-1.8%, higher than those without stirring. The COD removal under stirring was 22.1+/-0.3%, which was slightly lower than that of 23.7+/-0.4% under no stirring. However, stirring resulted in 59% lower xylose degradation rate. This work demonstrates that xylose can be used in the MFC for electricity production. Comparatively higher electricity generation and coulombic efficiency can be obtained by adjusting initial xylose concentration and applying stirring in the anode chamber.

China has achieved impressive rapid economic growth over the past 30 years but accompanied by significant extreme weather events and environmental changes caused by global change and overfast urbanization. Using the absolute hazards index (AHI), we assessed the spatial distribution patterns and related health effects of 4 major extreme natural disasters, including drought, floods (landslides, mudslides), hails, and typhoons from 2000 to 2011 at the provincial level in China. The results showed that (1) central and south China were the most affected by the 4 natural disasters, and north China suffered less; (2) the provinces with higher AHI suffered most from total death, missing people, collapse, and emergently relocated population; (3) the present health emergency response system to disasters in China mainly lacks a multidisciplinary approach. In the concluding section of this article, suggestions on preparedness and rapid response to extreme health events from environmental changes are proposed.

Decreasing nutrient losses from excessive synthetic fertilizer inputs is the direct and valid way to address low nutrient use efficiency and the related environmental consequences. Here, we established a comprehensive database of nitrogen (N), phosphorus (P), and carbon (C) losses from rice paddy fields in China, which we used to evaluate fertilization-induced losses and the impact of environmental factors, and to mitigate losses by adopting alternative fertilization options and setting input thresholds. Our results showed that most N-loss pathways had exponential increases with additional N input. In average, 23.8% of the N applied was lost via NH3 (16.1%), N2O (0.3%), leaching (4.8%), and runoff (2.6%). Total P loss was approximately 2.7% of the input, composed of leaching (1.3%) and runoff (1.4%). C lost as CH4 accounted for 4.9% of the organic C input. A relative importance analysis indicated that climate or soil variation rather than fertilizer rate was the dominant factor driving N and P leaching, and CH4 emissions. Based on the sensitivity of multiple N-loss pathways to N fertilization, we propose upper thresholds for N inputs of 142–191 kg N ha−1 across four rice types, which would avoid dramatic increases in N losses. Compared to conventional chemical fertilization, alternative fertilization options had diverse performances: enhanced-efficiency N fertilizer reduced N loss rate by 7.8 percent points and the global warming potential (GWP, considering N2O and CH4 emissions) by 28.8%; combined manure and chemical N fertilizer reduced N loss rate by 9.0 percent points but increased the GWP by 56.9%; straw return had no effect on total N loss but almost doubled the GWP. Using nutrient sources most appropriate to site-specific conditions is demonstrated as a robust way to decrease nutrient losses. Setting nutrient input thresholds would also contribute to the mitigation of environmental pollution, especially in regions with poor fertilization recommendation systems.

Abstract Electrolyte-separator-free fuel cell (EFFC) is a new emerging energy conversion technology. The EFFC consists of a single-component of nanocomposite material which works as a one-layer fuel cell device contrary to the traditional three-layer anode–electrolyte–cathode structure, in which an electrolyte layer plays a critical role. The nanocomposite of a single homogenous layer consists of a mixture of semiconducting and ionic materials that provides the necessary electrochemical reaction sites and charge transport paths for a fuel cell. These can be accomplished through tailoring ionic and electronic (n, p) conductivities and catalyst activities, which enable redox reactions to occur on nano-particles and finally accomplish a fuel cell function.

The effect of substrate changes on the performance and microbial community of two-chamber microbial fuel cells (MFCs) was investigated in this study. The MFCs enriched with a single substrate (e.g., acetate, glucose, or butyrate) had different acclimatization capability to substrate changes. The MFC enriched with glucose showed rapid and higher power generation, when glucose was switched with acetate or butyrate. However, the MFC enriched with acetate needed a longer adaptation time for utilizing glucose. Microbial community was also changed when the substrate was changed. Clostridium and Bacilli of phylum Firmicutes were detected in acetate-enriched MFCs after switching to glucose. By contrast, Firmicutes completely disappeared and Geobacter-like species were specifically enriched in glucose-enriched MFCs after feeding acetate to the reactor. This study further suggests that the type of substrate fed to MFC is a very important parameter for reactor performance and microbial community, and significantly affects power generation in MFCs.