• Energy Research
• 2016-2025close
• Open Access close
• Restricted close
• Open Source close
• Embargo close
• EU close
• NL close

AbstractDecarbonising the energy system requires high shares of variable renewable generation and sector coupling like power to heat. In addition to heat supply, heat pumps can be used in future energy systems to provide flexibility to the electricity system by using the thermal storage potential of the building stock and buffer tanks to shift electricity demand to hours of high renewable electricity production. Bridging the gap between two methodological approaches, we coupled a detailed building technology operation model and the open-source energy system model Balmorel to evaluate the flexibility potential that decentral heat pumps can provide to the electricity system. Austria in the year 2030 serves as an example of a 100% renewable-based electricity system (at an annual national balance). Results show that system benefits from heat pump flexibility are relatively limited in extent and concentrated on short-term flexibility. Flexible heat pumps reduce system cost, CO2 emissions, and photovoltaics and wind curtailment in all scenarios. The amount of electricity shifted in the assessed standard flexibility scenario is 194 GWhel and accounts for about 20% of the available flexible heat pump electricity demand. A comparison of different modelling approaches and a deterministic sensitivity analysis of key input parameters complement the modelling. The most important input parameters impacting heat pump flexibility are the flexible capacity (determined by installed capacity and share of control), shifting time limitations, and cost assumptions for the flexibility provided. Heat pump flexibility contributes more to increasing low residual loads (up to 22% in the assessed scenarios) than decreasing residual load peaks. Wind power integration benefits more from heat pump flexibility than photovoltaics because of the temporal correlation between heat demand and wind generation.

This report reflects upon the concept of social innovation and the way it is used in the energy sector. It does so by bringing together theoretical investigations and empirical knowledge. We aim to clarify the concept of social innovation in the energy sector by reviewing the literature and reflecting over a number of social innovation projects in Europe. The analysis of the projects against various contextual factors and their goals reveals the significant potential of social innovation on accelerating the energy transition while tackling societal problems. Energy production, energy efficiency and energy literacy are the main domains to which socially innovative activities contribute the most. High competences of project leadership and management observed though projects are often small in scale and context-dependent. This indicates that successful socially innovative energy initiatives require advanced bottom-up governance structures even if that may imply limitations for scaling up. This setting may complicate top-down support as legal, financial or even cultural policy-making must be tailor-made and reinvent or adjust continuously. Nevertheless, social innovative activities are expected to further proliferate the following years and move towards a sound environmental, cultural, political, economic and social direction, as knowledge creation and diffusion of technological and governance innovations accompanied with policy support are on the rise. JRC.C.7-Knowledge for the Energy Union

AbstractElevated CO2 concentration has been reported to decrease grain nutrient concentrations and thus worsen nutritional deficiency and hidden hunger. One nutritional aspect is mineral content, yet mineral bioavailability can be limited by the presence of phytic acid. Given that future climate scenarios predict elevated global temperature driven by elevated atmospheric CO2 concentrations, we used Temperature by Free‐Air CO2 Enrichment (T‐FACE) field experiments to investigate whether elevated temperature alters the effects of elevated CO2 on grain mineral concentrations, grain mineral yields, and their bioavailability in a range of wheat and rice genotypes. We found that the negative effects of elevated CO2 were compensated for by positive effects of elevated temperature. As a result, the combined elevated CO2 and elevated temperature increased concentrations of some minerals by up to ~15% in both rice and wheat relative to control conditions. Moreover, the combined elevated CO2 and elevated temperature did not significantly change total yields of some minerals despite lower grain yields. The combined CO2 and temperature elevation increased phytic acid concentration in rice by 18.1% but decreased it in wheat by 3.5%. The mineral bioavailability, estimated as the mole ratio of phytic acid to minerals in rice and wheat grains, was limited by the combined CO2 and temperature elevation in only a few cases. Our results indicate that under future climate conditions of elevated temperature and CO2, the nutritional quality of rice and wheat with respect to minerals may remain unchanged.

Abstract. Flooding in the Amazon basin is frequently attributed to modes of large-scale climate variability, but little attention is paid to how these modes influence the timing and duration of floods despite their importance to early warning systems and the significant impacts that these flood characteristics can have on communities. In this study, river discharge data from the Global Flood Awareness System (GloFAS 2.1) and observed data at 58 gauging stations are used to examine whether positive or negative phases of several Pacific and Atlantic indices significantly alter the characteristics of river flows throughout the Amazon basin (1979–2015). Results show significant changes in both flood magnitude and duration, particularly in the north-eastern Amazon for negative El Niño–Southern Oscillation (ENSO) phases when the sea surface temperature (SST) anomaly is positioned in the central tropical Pacific. This response is not identified for the eastern Pacific index, highlighting how the response can differ between ENSO types. Although flood magnitude and duration were found to be highly correlated, the impacts of large-scale climate variability on these characteristics are non-linear; some increases in annual flood maxima coincide with decreases in flood duration. The impact of flood timing, however, does not follow any notable pattern for all indices analysed. Finally, observed and simulated changes are found to be much more highly correlated for negative ENSO phases compared to the positive phase, meaning that GloFAS struggles to accurately simulate the differences in flood characteristics between El Niño and neutral years. These results have important implications for both the social and physical sectors working towards the improvement of early warning action systems for floods.

The energy considered as waste heat in industrial furnaces owing to inefficiencies represents a substantial opportunity for recovery by means of thermal energy storage (TES) implementation. Although conventional systems based on sensible heat are used extensively, these systems involve technical limitations. Latent heat storage based on phase change materials (PCMs) results in a promising alternative for storing and recovering waste heat. Within this scope, the proposed PCM-TES allows for demonstrating its implementation feasibility in energy-intensive industries at high temperature range. The stored energy is meant to preheat the air temperature entering the furnace by using a PCM whose melting point is 885 °C. In this sense, a heat transfer model simulation is established to determine an appropriate design based on mass and energy conservation equations. The thermal performance is analysed for the melting and solidification processes, the phase transition and its influence on heat transference. Moreover, the temperature profile is illustrated for the PCM and combustion air stream. The obtained results prove the achievability of very high temperature levels (from 700 to 865 °C) in the combustion air preheating in a ceramic furnace; so corroborating an energy and environmental efficiency enhancement, compared to the initial condition presenting an air outlet at 650 °C.