• Energy Research
• 2021-2025close
• 6. Clean water close
• US close
• GB close
• IT close
• RU close

Considerable interest is being shown in using biochar production from waste biomass with a variety of disciplines to address the most pressing environmental challenges. Biochar produced by the thermal decomposition of biomass under oxygen-limited conditions is gaining popularity as a low-cost amendment for agro-ecosystems. The efficiency of biochar formation is affected by temperature, heating rate, feedstock type, particle size and reactor conditions. Properties such as pH, surface area and ash content of produced biochar increases with increasing temperatures. Biochar produced at lower heating rates may have high porosity and be beneficial for morphological changes in the soil. Biochar can help to enhance soil health and fertility as well as improve agricultural yield. As a result, biochar can assist in increasing food security by promoting sustainable agricultural systems and preserving an eco-friendly environment. Biochar is also widely being used as a sorbent for organic and inorganic pollutants, owing to its large surface area, allowing it to be immobilized from soil with ease. The functional groups and charges present on the surface of biochar play an important role in pollutants removal. This review focuses on the mechanisms of biochar production using different waste materials as a feed stock, factors that influence biochar quality as well as application of biochar in agricultural soil and their reclamation as well. This article also discusses knowledge gaps and future perspectives in the field of biochar-based toxic-pollution remediation.

Considerable interest is being shown in using biochar production from waste biomass with a variety of disciplines to address the most pressing environmental challenges. Biochar produced by the thermal decomposition of biomass under oxygen-limited conditions is gaining popularity as a low-cost amendment for agro-ecosystems. The efficiency of biochar formation is affected by temperature, heating rate, feedstock type, particle size and reactor conditions. Properties such as pH, surface area and ash content of produced biochar increases with increasing temperatures. Biochar produced at lower heating rates may have high porosity and be beneficial for morphological changes in the soil. Biochar can help to enhance soil health and fertility as well as improve agricultural yield. As a result, biochar can assist in increasing food security by promoting sustainable agricultural systems and preserving an eco-friendly environment. Biochar is also widely being used as a sorbent for organic and inorganic pollutants, owing to its large surface area, allowing it to be immobilized from soil with ease. The functional groups and charges present on the surface of biochar play an important role in pollutants removal. This review focuses on the mechanisms of biochar production using different waste materials as a feed stock, factors that influence biochar quality as well as application of biochar in agricultural soil and their reclamation as well. This article also discusses knowledge gaps and future perspectives in the field of biochar-based toxic-pollution remediation.

The growing population and increasing urbanization have led to a surge in domestic wastewater generation, posing significant challenges for effective and sustainable treatment. The present study demonstrates a novel and sustainable approach for the onsite treatment of domestic wastewater using an integrated settler-based biofilm reactor (ISBR) with efficient biogas generation. The ISBR provides an optimized environment for the growth of biofilm, facilitating the removal of organic pollutants and pathogens. Moreover, the ISBR enables the recovery of a valuable resource in the form of biogas, thus enhancing the overall utility of the treatment process. The performance of the ISBR was comprehensively evaluated at laboratory scale through treating the actual domestic wastewater generated from the hostel of Manipal University Jaipur. The ISBR system was operated under an ambient environment at a hydraulic retention time (HRT) of 24 h. The results demonstrated remarkable efficiency in terms of chemical oxygen demand (COD), total suspended solids (TSS), and coliforms removal, with average removal efficiency being more than 90%. According to the COD mass balance analysis, 48.2% of the influent COD was recovered as bioenergy. The chromatogram revealed a high percentage of methane gas in the collected biogas sample. The field emission scanning electron microscope (FESEM) analysis of the accumulated sludge in the ISBR system depicted the morphology of methanogenic bacteria. Both the experimental and theoretical results confirmed the feasibility and sustainability of the ISBR system at the onsite level.

The growing population and increasing urbanization have led to a surge in domestic wastewater generation, posing significant challenges for effective and sustainable treatment. The present study demonstrates a novel and sustainable approach for the onsite treatment of domestic wastewater using an integrated settler-based biofilm reactor (ISBR) with efficient biogas generation. The ISBR provides an optimized environment for the growth of biofilm, facilitating the removal of organic pollutants and pathogens. Moreover, the ISBR enables the recovery of a valuable resource in the form of biogas, thus enhancing the overall utility of the treatment process. The performance of the ISBR was comprehensively evaluated at laboratory scale through treating the actual domestic wastewater generated from the hostel of Manipal University Jaipur. The ISBR system was operated under an ambient environment at a hydraulic retention time (HRT) of 24 h. The results demonstrated remarkable efficiency in terms of chemical oxygen demand (COD), total suspended solids (TSS), and coliforms removal, with average removal efficiency being more than 90%. According to the COD mass balance analysis, 48.2% of the influent COD was recovered as bioenergy. The chromatogram revealed a high percentage of methane gas in the collected biogas sample. The field emission scanning electron microscope (FESEM) analysis of the accumulated sludge in the ISBR system depicted the morphology of methanogenic bacteria. Both the experimental and theoretical results confirmed the feasibility and sustainability of the ISBR system at the onsite level.

Dolomite-based binders are characterised by interesting technical and environmental features. For their synthesis, sources of both CaO and MgO are required. The idea developed in this work is to couple the synthesis of dolomite-based binders, starting from a natural dolomite, through the concept of concentrated solar energy (needed to drive the endothermal dolomite calcination process) in fluidised bed reactors. To this end, a fluidised bed system, where the concentrated solar radiation is mimicked by the use of Xe-lamps (short-arc), has been set up and operated. Natural dolomite (sieved in the 420-590 ?m size range) was calcined at a nominal temperature of 850 °C, and bed temperature profiles during solar-driven calcination were investigated. Then, four binders were prepared by mixing slaked dolomite (obtained from the hydration of solar calcined dolomite) with either blast furnace slag or coal fly ash as supplementary cementitious materials. The binders were hydrated for curing times ranging from 7 to 56 days. X-ray fluorescence, X-ray diffraction and combined differential thermal and thermogravimetric analyses were employed as characterisation techniques both to analyse the chemical composition of starting materials and to investigate the evolution of the hydration in the four systems.

Dolomite-based binders are characterised by interesting technical and environmental features. For their synthesis, sources of both CaO and MgO are required. The idea developed in this work is to couple the synthesis of dolomite-based binders, starting from a natural dolomite, through the concept of concentrated solar energy (needed to drive the endothermal dolomite calcination process) in fluidised bed reactors. To this end, a fluidised bed system, where the concentrated solar radiation is mimicked by the use of Xe-lamps (short-arc), has been set up and operated. Natural dolomite (sieved in the 420-590 ?m size range) was calcined at a nominal temperature of 850 °C, and bed temperature profiles during solar-driven calcination were investigated. Then, four binders were prepared by mixing slaked dolomite (obtained from the hydration of solar calcined dolomite) with either blast furnace slag or coal fly ash as supplementary cementitious materials. The binders were hydrated for curing times ranging from 7 to 56 days. X-ray fluorescence, X-ray diffraction and combined differential thermal and thermogravimetric analyses were employed as characterisation techniques both to analyse the chemical composition of starting materials and to investigate the evolution of the hydration in the four systems.

AbstractAn increase in heavy precipitation associated with climate change has exacerbated flooding in the Eastern U.S. To assess regional flood risk with changing climatic conditions, we demonstrate the application of a novel hydrologic modeling framework that integrates climate projections with a coupled Noah‐MP land surface model and a two‐dimensional HEC‐RAS hydrodynamic model. We employ this framework along a 41 km reach of the Susquehanna River near Harrisburg, Pennsylvania, where recent flood damages exceeded $2 billion (2011 Irene and Lee floods). Historical and future 30‐year and 100‐year peak‐discharge estimates were compared to assess how flood risk might be altered due to climate change. Results indicate that precipitation increases from climate change do not always lead to increases in flood risk, because interplay of hydrological components in the watershed, which are considered by Noah‐MP, largely controls flooding severity. However, climate change is expected to increase the severity of extreme events; if a 50‐year flood (the recurrence interval of Tropical Storm Lee) occurred toward the end of the 21st century in the worst‐case emission scenario, then flood volume would increase by 40% and flood extent by 15%, due to an increase in soil moisture from a wetter overall climate.

AbstractAn increase in heavy precipitation associated with climate change has exacerbated flooding in the Eastern U.S. To assess regional flood risk with changing climatic conditions, we demonstrate the application of a novel hydrologic modeling framework that integrates climate projections with a coupled Noah‐MP land surface model and a two‐dimensional HEC‐RAS hydrodynamic model. We employ this framework along a 41 km reach of the Susquehanna River near Harrisburg, Pennsylvania, where recent flood damages exceeded $2 billion (2011 Irene and Lee floods). Historical and future 30‐year and 100‐year peak‐discharge estimates were compared to assess how flood risk might be altered due to climate change. Results indicate that precipitation increases from climate change do not always lead to increases in flood risk, because interplay of hydrological components in the watershed, which are considered by Noah‐MP, largely controls flooding severity. However, climate change is expected to increase the severity of extreme events; if a 50‐year flood (the recurrence interval of Tropical Storm Lee) occurred toward the end of the 21st century in the worst‐case emission scenario, then flood volume would increase by 40% and flood extent by 15%, due to an increase in soil moisture from a wetter overall climate.